Microstructure and Performance of High-Velocity Oxygen-Fuel Coupled Physical Vapor Deposition (HVOF-PVD) Duplex Protective Coatings: A Review
نویسندگان
چکیده
The paper summarizes the current development of high-velocity oxygen–fuel coupled physical vapor deposition (HVOF-PVD) duplex coatings as protective candidates. Following a detailed historical overview HVOF and PVD technologies, fabrication methods for are presented. coating superimposes synergistic advantages deposited by PVD, where traditional weaknesses each technique modified to great certain extent. Subsequently, relation between structural characteristics their mechanical, tribological, corrosive behavior is described in detail. It demonstrated that show more excellent overall performance than both separately. Finally, we summarize promising potential HVOF-PVD applications well research prospects challenges future.
منابع مشابه
Possibilities of Utilization High Velocity Oxygen Fuel (hvof) Coatings in Conditions of Thermal Cyclic Loading
The item deals with the possibilities of utilization HVOF coatings in thermal cyclic loading conditions. There were evaluated three types of coatings based on WC-Co, WC-Co-Cr and Cr3C2-25NiCr. The quality of coatings was evaluated in terms of their adhesion as sprayed and also during the cyclic thermal loading, EDX analysis and evaluation of microhardness. Construction and structure of coatings...
متن کاملHemocompatibility of Inorganic Physical Vapor Deposition (PVD) Coatings on Thermoplastic Polyurethane Polymers
Biocompatibility improvements for blood contacting materials are of increasing interest for implanted devices and interventional tools. The current study focuses on inorganic (titanium, titanium nitride, titanium oxide) as well as diamond-like carbon (DLC) coating materials on polymer surfaces (thermoplastic polyurethane), deposited by magnetron sputtering und pulsed laser deposition at room te...
متن کاملTechnique in Measuring Residual Stresses of Physical Vapor Deposition (PVD) Hard Coatings
Residual stresses of physical vapor deposition (PVD) hard coatings can be measured using X-ray diffraction (XRD) methods under either conventional d-sin2 ψ mode or glancing incident (GIXRD) mode, in which substantial uncertainties exist depending on the applied diffraction parameters. This paper reports systematic research on the effect of the two analytical modes, as well as the anisotropic el...
متن کاملApplication of High-Velocity Oxygen-Fuel (HVOF) Spraying to the Fabrication of Yb-Silicate Environmental Barrier Coatings
From the literature, it is known that due to their glass formation tendency, it is not possible to deposit fully-crystalline silicate coatings when the conventional atmospheric plasma spraying (APS) process is employed. In APS, rapid quenching of the sprayed material on the substrate facilitates the amorphous deposit formation, which shrinks when exposed to heat and forms pores and/or cracks. T...
متن کاملCharacterization of hydroxyapatiteynano-zirconia composite coatings deposited by high velocity oxy-fuel (HVOF) spray process
Hydroxyapatite (HA)ynano-zirconia composite coatings were successfully produced through high velocity oxy-fuel (HVOF) spraying of radio frequency (RF) plasma synthesized powders. Microstructure characterization and morphology analysis on the nano-structured coatings were conducted using scanning electron microscopy (SEM), transmission electron microscopy (TEM), X-ray diffractometry (XRD), and d...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Coatings
سال: 2022
ISSN: ['2079-6412']
DOI: https://doi.org/10.3390/coatings12101395