Microstructure and Mechanical Properties of P/M Al-Fe-Cr-Ti-Mm (Mm: Misch Metal) and Al-V-Fe-Mm Alloys.
نویسندگان
چکیده
منابع مشابه
Thermal Stability, Microstructure and Mechanical Properties of Nanostructured Al-Ni-Mm-X (X=Cu and Fe) Alloys Hot-Extruded from Gas-Atomized Powders
Dept. of Nano System Engineering, Pusan National University, 50 Cheonghak Samrangjin-eup, Miryang, Kyungnam, Korea Advanced Materials Processing and Analysis Center (AMPAC), Department of Mechanical, Materials and Aerospace Engineering, University of Central Florida, Orlando, FL 32816-2455, USA Division of Advanced Materials Engineering, Kongju National University, 275, Budae-dong, Cheonan City...
متن کاملAtomistic Study of Surfaces and Interfaces of Fe-Cr and Fe-Cr-Al Alloys
Surface and interface properties of Fe-Cr, Fe-Al, and Fe-Cr-Al are studied using Exact Muffin-Tin Orbitals and Monte Carlo methods and with x-ray photoelectron and Auger electron techniques. Surface composition is investigated as a function of oxidation (heating) time. Hard x ray photoelectron spectroscopy (HAXPES) is used to scan non destructively the compositions below the surface. It is foun...
متن کاملSynthesis, characterization and hydrogen storage properties of Mm(Ni,Co,Mn,Al)5 alloy
The hydrogenation characterizations of the hydrogen storage alloy MmNi4.22Co0.48Mn0.15Al0.15 (Mm= mischmetal), and the effect of hydrogenation/dehydrogenation (H/D) cycling on its structural and morphological properties are investigated. The results indicate that after several H/D cycles the alloy was pulverized into fine particles, but it kept its hexagonal CaCu5-type structure. The pressure-c...
متن کاملCALCULATION OF THERMODYNAMIC PROPERTIES OF Al-Fe, Al-Ni AND Ni-Fe ALLOYS USING FACTSAGE
Thermodynamic predicting analysis of three binary systems Al-Fe, Al-Ni and Ni-Fe are shown in this paper. Thermodynamic analysis involved calculation of activities, coefficient of activities, partial and integral values for enthalpies and Gibbs energies of mixing and excess energies at three different temperatures: 1873K, 1900K and 1973K, as well as calculated phase diagrams, for the investigat...
متن کاملHydriding / dehydriding of Mg 87 Ni 3 Al 3 Mm 7 ( Mm = La , Ce -
10 Nanocrystalline Mg87Ni3Al3Mm7 hydrides were produced by reactive mechanical milling (RMM) under hydrogen atmosphere. Milling first under argon, and then under hydrogen atmosphere was also carried out in order to study the effect of the gas atmosphere on the microstructure of the products of milling as well as on their hydriding properties. In both cases, the main product of the milling proce...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society of Powder and Powder Metallurgy
سال: 2001
ISSN: 0532-8799,1880-9014
DOI: 10.2497/jjspm.48.1126