Microstructure and Mechanical Properties of Mg-Al-Sn Alloy Sheet Produced by Large Strain Rolling

Influence of Rolling Temperature on Microstructure and Mechanical Properties of Cryorolled Al-Mg-Si Alloy

An effect of rolling temperature on the mechanical properties and microstructural evolution of an Al-Mg-Si alloy was studied. The material was rolled up to a true strain of ∼0.7 at three different temperatures viz; room temperature, liquid propanol and liquid nitrogen. The liquid nitrogen rolled sample exhibited superior properties with a yield and tensile strength of 332 MPa and 364 MPa, respe...

Optimization of Microstructure and Mechanical Properties of Al-A360 Produced by Semi-Solid Casting

Semi-Solid Casting (SSM) is a new process that could produce globular structures with mechanical properties. The cooling slope method (CLM) is a one of this process that was employed to produce the A360 feedstock. In this method, The dendritic primary phase in the conventionally cast A356 alloy has transformed into a non-dendritic one. In this paper, The molten alloy with the temperature (PT) o...

Al-7Si-Mg Semi-Solid Castings – Microstructure and Mechanical Properties

Improving of Microstructure and Mechanical Properties of Al-A356 Alloy with Compo-Casting Method

Aluminum/alumina composites are used in automotive and aerospace industries due to their low density and good mechanical strength. In this research, the effect of mechanical stirring of slurry in liquid-solid phase temperature and injection of alumina powder with inert gas (Ar) on microstructure and mechanical properties of Al-A356 alloy is investigated. In order to improve of the wettability a...

Experimental Analysis of Microstructure and Mechanical Behaviour in Fine Grained Al-Zn-Mg Alloy

The high strength Al-Zn-Mg alloy is widely used for structure components in critical aerospace applications. Small additions of scandium (Sc) often refine cast microstructure and mechanical properties by forming metastable Al3Sc dispersoids. The main role of the Al3Sc dispersoid is to prevent recrystallization during hot deformation and solution treatment. A new technique to apply for surface m...