Microstructure and fracture behaviour of Ti3Al/TC4 dissimilar materials joints welded by electron beam
نویسندگان
چکیده
منابع مشابه
Micro-Study of Dissimilar Welded Materials
The dissimilar joint between aluminum/titanium alloys (Al 6082 and Ti G2) were successfully achieved by CO2 laser welding with a single pass and without filler material using the overlap joint design. Laser welding parameters ranges combinations were experimentally determined using Taguchi approach with the objective of producing welded joint with acceptable welding profile and high quality of ...
متن کاملControl of Welding Residual Stress for Dissimilar Laser Welded Materials
The most common problem of welding dissimilar metals (DMWs) with respect to residual stresses is the differences in the coefficient of thermal expansion and heat conductivity of the two welded metals. In the present work, a CO2 continuous laser welding process was successfully applied and optimized for joining a dissimilar AISI 316 stainless steel and low carbon steel plates. The Taguchi approa...
متن کاملRelation between Residual Stress and Fatigue Strength for Electron Beam Welded Joints of Sheet Metal
Residual stresses in welds significantly affect the fatigue strength and stress corrosion crack resistance of the weld joint, and therefore, numerous studies have been made about the effects. The residual stress induced by electron beam welding (EBW) has also been researched in various approaches, but many of the study reports dealt with thick plates (50 mm or thicker) only.1–5) This was becaus...
متن کاملFatigue Behaviour Study of Laser Hybrid Welded Eccentric Fillet Joints – Part Ii: State-of-the-art of Fracture Mechanics and Fatigue Analysis of Welded Joints
Simplified fatigue and fracture mechanics based assessment methods are widely used by the industry to determine the structural integrity significance of postulated cracks, manufacturing flaws, service-induced cracking or suspected degradation of engineering components under normal and abnormal service loads. In many cases, welded joints are the regions most likely to contain original fabricatio...
متن کاملOptimization of Process Parameters of Electron Beam Welded Fe49Co2V Alloys
Electron beam welding has shown a remarkable job in the space industry for welding of components. It is performed under a vacuum environment that eliminates foreign matter such as hydrogen, oxygen, and other gases. Joining of similar and dissimilar materials is the main advantage of electron beam welding with high depth to width ratio as well as sharp focus at the point where parts are to be we...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Bulletin of Materials Science
سال: 2010
ISSN: 0250-4707,0973-7669
DOI: 10.1007/s12034-011-0148-7