Microstructure and Cleanliness of Rapidly Solidified Steels
نویسندگان
چکیده
منابع مشابه
TEM INVESTIGATION OF RAPIDLY SOLIDIFIED NDFEB HARD MAGNETIC MATERIAL
The surface condition and microstructure of near stoichiometric (Fe823Ndll.8B5.9) Nd-Fe-B alloy ribbons and the effect of melt spinning parameters were investigated using optical, scanning and transmission electron microscopes (SEM, TEM). The formation of gas pockets on the roll surface of the ribbons during melt spinning can prevent heat transform and result in local coarse grains. The local t...
متن کاملMICROSTRUCTURE OF A RAPIDLY SOLIDIFIED Al-4V-2Fe ULTRAHIGH STRENGTH ALUMINUM ALLOY
Microstructure of a rapidly solidified Al-4V-2Fe alloy has been examined in detail by means of transmission electron microscopy and atom probe field ion microscopy. It is composed of a mixture of α-Al and amorphous phases. α-Al grains are relatively large (400 nm), but nanoscale domains of amorphous phase are trapped in the fcc grains. The interface between the α-Al and amorphous phases are ver...
متن کاملRapidly Solidified Magnetic Nanowires and Submicron Wires
Magnetically soft amorphous glass-coated microwires are suitable for numerous sensor applications. Their typical dimensions – metallic nucleus diameter of 1 to 50 m and glass coating thickness of 1 to 30 m – make them promising candidates for high frequency applications, especially given their sensitive giant magneto-impedance (GMI) response in the MHz and GHz ranges (Torrejón et al, 2009). T...
متن کاملMicrostructure and cleavage in lath martensitic steels
In this paper we discuss the microstructure of lath martensitic steels and the mechanisms by which it controls cleavage fracture. The specific experimental example is a 9Ni (9 wt% Ni) steel annealed to have a large prior austenite grain size, then examined and tested in the as-quenched condition to produce a relatively coarse lath martensite. The microstructure is shown to approximate the recen...
متن کاملModelling the Microstructure of Martensitic Steels
A method based on the kinetics of crystal growth has been developed and applied to the computation of three-dimensional microstrucuture in austenite-matensite steels. The detailed crystallography of the transformation is used to model a realistic martensitic microstrucuture during the transformation without an external system of stresses. The interaction energy based on the plastic work model i...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: ISIJ International
سال: 2003
ISSN: 0915-1559
DOI: 10.2355/isijinternational.43.1724