Microstructural Features and Formation Processes of As-cast Austenite Grain Structures in Hypoperitectic Carbon Steels
نویسندگان
چکیده
منابع مشابه
Metallographic techniques for the determination of the austenite grain size in medium-carbon microalloyed steels
Different techniques have been investigated to seek the best procedure to reveal the prior-austenite grain boundaries in three medium-carbon microalloyed steels. This study has been carried out over a wide range of temperatures (950–1250 C) and it has been found that thermal etching (TE) is the best technique to reveal the prior-austenite grain boundaries in these steels. D 2001 Elsevier Scienc...
متن کاملMicrostructural control of the austenite stability in low-alloyed TRIP steels
We have performed in-situ magnetization and high-energy X-ray diffraction measurements on two aluminum-based TRIP steels from room temperature down to 100 K in order to evaluate amount and stability of the retained austenite for different heat treatment conditions. We have found that the bainitic holding temperature affects the initial fraction of retained austenite at room temperature but does...
متن کاملTHE EFFECT OF COOLING RATE AND AUSTENITE GRAIN SIZE ON THE AUSTENITE TO FERRITE TRANSFORMATION TEMPERATURE AND DIFFERENT FERRITE MORPHOLOGIES IN MICROALLOYED STEELS
Abstract: transformation temperature and different ferrite morphologies in one Nb-microalloyed (HSLA) steel has beeninvestigated. Three different austenite grain sizes were selected and cooled at two different cooling rates for obtainingaustenite to ferrite transformation temperature. Moreover, samples with specific austenite grain size have beenquenched, partially, for investigation on the mic...
متن کاملEffect of austenite grain size and bainite morphology on overall kinetics of bainite transformation in steels
The effect of austenite grain size on the evolution of the bainite transformation in steels is not yet certain in spite of many investigations.1–7 Barford and Owen1 reported that the reaction rate was accelerated by decreasing the grain size, because of an increase in the number density of grain boundary nucleation sites. Umemoto et al.2 reported similar results and proposed an equation that de...
متن کاملInfluence of Boron on Initial Austenite Grain Size and Hot Deformation Behavior of Boron Microalloyed Steels
The initial austenite grain size of boron microalloyed steel with three different amounts of boron (20, 40, and 60 ppm) was investigated under different heating temperatures (1150, 1100, and 1050 °C), and hot compression tests of samples in a wide range of temperature (900–1100 °C) and strain rate (0.1–10 s−1) were conducted. It was found that the initial austenite grain size increases with inc...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: ISIJ International
سال: 2015
ISSN: 0915-1559,1347-5460
DOI: 10.2355/isijinternational.isijint-2015-240