Microstructural evolution under tempering heat treatment in AISI H13 hot-work tool steel
نویسندگان
چکیده
منابع مشابه
Hot Forming of Aisi A2 Tool Steel
In order to optimize the hot forming process of tool steels, further improvement of flow stress prediction and additional knowledge on hot deformability, especially at lower and upper limits of the hot working range, are required. The hot working ranges for these steels are very narrow as a consequence of the role of alloying elements, which form carbides. Carbides improve tool steel’s hardenab...
متن کاملEVALUATION OF THE MECHANICAL PROPERTIES OF NIOBIUM MODIFIED CAST AISI H 13 HOT WORK TOOL STEEL
Abstract: mechanical properties of AISIH 13 hot-work tool steel have been studied. Cast samples made of the modified new steel were homogenized and austenitized at different conditions, followed by tempering at the specified temperature ranges. Hardness, red hardness, three point bending test and Charpy impact test were carried out to evaluate the mechanical properties together with characteriz...
متن کاملMicrostructural Evolution of X45CrNiW189 Valve Steel During Hot Deformation
The hot compression tests were carried on X45CrNiW189 valve steel (X45) in the temperature range of 1000– 1200 °C and the strain rate range of 0.004 – 0.5 s-1 in order to study the high temperature softening behavior of this steel. For the exact prediction of flow stress, the effective stress-effective strain curves were obtained from experiments under various conditions. On the basis of experi...
متن کاملNickel-based Superalloy Layer Deposited on AISI H13 Hot Tool Steel Base Metal Using Explosion Cladding process
An experimental test was carried out to explosively clad solution annealed Inconel 718 superalloy on quench-tempered AISI H13 hot tool steel. A wavy with vortices interface geometry was obtained from this experiment. A gradual change in the wavelength along the direction of welding was observed which was due to a change in the impact angle, following the plate contacts. In this paper, the exper...
متن کاملSurface integrity predictions and optimisation of machining conditions in the turning of AISI H13 tool steel
Surface integrity (SI) plays a very important role in functional performance. It is dependent on a large number of machining parameters. The major concern of industry is to know which combination of machining parameters provides the best SI of machined components. Traditionally, surface roughness is considered to be the principal parameter to assess the SI of a machined part. However, residual ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal of Engineering Research and Applications
سال: 2017
ISSN: 2248-9622,2248-9622
DOI: 10.9790/9622-0704046771