Microstructural Evolution and Microhardness of Direct Laser Clad TiC Dispersed Titanium Aluminide (Ti45Al5Nb0.5Si) Alloy
نویسندگان
چکیده
منابع مشابه
Mechanical properties and microstructural evolution of vacuum hot-pressed titanium and Ti-6Al-7Nb alloy.
Hot-pressing is a powder metallurgy process where loose powder is loaded into a mould, usually of graphite, and sintered by the simultaneous application of high temperature and pressure. In this study elemental titanium and Ti-6Al-7Nb alloy powders are hot-pressed under different conditions in order to study the influence of the processing parameters on the microstructure and mechanical propert...
متن کاملInfluence of Hot Rolling and Heat Treatment on the Microstructural Evolution of β20C Titanium Alloy
The microstructural evolution and underlying mechanism of a new high strength, high toughness near β titanium alloy, β20C, during hot deformation, and heat treatment were studied qualitatively and quantitatively. It was found that dynamic recovery occurs mainly in β phase, while α phase undergoes both a dynamic recovery and continuous incomplete dynamic recrystallization with a fraction of high...
متن کاملMicrostructural Evolution of Roll Bonded Al-Clad Stainless Steel Sheets at Elevated Temperatures
The cold roll bonding of Al on AISI 304L stainless steel was carried out to fabricate the Al/304L/Al clad sheet composites. The maximum bond strength of 20 N/mm was acquired just by 38% reduction, for which the tearing of the aluminum sheet occurred during the peeling test. The microstructural evolution during subsequent postannealing heat treatment was systematically studied based on the impur...
متن کاملMicrostructural Evolution of Copper-Titanium Alloy during In-situ Formation of TiB2 Particles
Bulk Cu-Ti alloy reinforced by TiB2 nano particles was prepared using in-situ reaction between Cu3.4wt.% Ti and Cu-0.7wt.% B along with rapid solidification and subsequent heat treatment for 1-10 hrs at 900oC. High-resolution transmission electron microscopy (HRTEM) characterization showed that primary TiB2 nano particles and TiB whiskers were formed by in-situ reaction between Ti and B in the ...
متن کاملMachinability evaluation of Titanium alloy in Laser Assisted Turning
The use of titanium and its alloys has increased in various industries recently, because of their superior properties of these alloys. Titanium alloys are generally classified as difficult to machine materials because of their thermo-mechanical properties such as high strength-to-weight ratio and low thermal conductivity. Laser Assisted Machining (LAM) improves the machinability of high strengt...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Procedia Manufacturing
سال: 2019
ISSN: 2351-9789
DOI: 10.1016/j.promfg.2019.06.030