Microstructural evaluation of aluminium alloy A365 T6 in machining operation
نویسندگان
چکیده
منابع مشابه
Feasibility study of friction stir welding of 6061-T6 aluminium alloy with AISI 1018 steel
The present work demonstrates that friction stir welding (FSW) is a feasible route for joining 6061 aluminium (Al) alloy to AISI 1018 steel. The weld has a good weld quality and is free of cracks and porosity. The tensile failure happened at the boundary between the nugget and thermomechanically affected zone of the base Al alloy, indicating that the weld has a higher joining strength. Despite ...
متن کاملInvestigation of the T4 and T6 Heat Treatment Cycles of Semi-Solid Processed Aluminium Alloy A356
The heat treatment cycles that are currently applied to semi-solid processed components are mostly those that are in use for dendritic casting alloys. These heat treatments are not necessarily the optimum treatments. It is shown that a decrease of the solution treatment time at 540 o C from 6 hours to 1 hour does not alter the T4 or T6 tensile properties of the SSM processed A356 alloy. Slightl...
متن کاملMicrostructural Evaluation of Ti-6AL-4V Alloy during Hot Deformation
Among the titanium alloys, Ti-6Al-4V is the most widely used. In the present work, the uniaxial hot compressive behavior of Ti-6Al-4V has been investigated under constant strain rates. A series of dilatometery experiments were carried out to determine the transformation temperatures at different cooling rates. Specimens were homogenized at 1050 °C for 10 minutes followed by fast cooling to dif...
متن کاملMicrostructural Evaluation of Ti-6AL-4V Alloy during Hot Deformation
Among the titanium alloys, Ti-6Al-4V is the most widely used. In the present work, the uniaxial hot compressive behavior of Ti-6Al-4V has been investigated under constant strain rates. A series of dilatometery experiments were carried out to determine the transformation temperatures at different cooling rates. Specimens were homogenized at 1050 °C for 10 minutes followed by fast cooling to dif...
متن کاملElectro Discharge Machining Of Aluminium Alloy (LM6)-5 wt.% SiCp Composites Using Copper Electrodes
Metal matrix composites (MMCs) are now gaining their usage in aerospace, automotive and biomedical industries because of their inherent properties like high strength to weight ratio, low wear rate etc. To machine these types of materials conventional machining methods are unsuitable because of high tool wear and tooling cost. Electro discharge Machining (EDM) is one of the important nontraditio...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Materials Research and Technology
سال: 2019
ISSN: 2238-7854
DOI: 10.1016/j.jmrt.2019.05.009