Microstructural Development in Friction Welded AZ31 Magnesium Alloy
نویسندگان
چکیده
منابع مشابه
Corrosion Behavior of the Friction Stir Welded AZ31 Magnesium Alloy.
* IDMEC, Instituto Superior Técnico, Universidade de Lisboa, Av. Rovisco Pais, 1049-001 Lisboa, Portugal ** DEQ/ICEMS, Instituto Superior Técnico, Universidade de Lisboa, Av. Rovisco Pais, 1049001 Lisboa, Portugal. *** Department of Engineering Design and Production, School of Engineering, Aalto University, P.O. Box 1420, FI-00076 Aalto, Finland **** Faculdade de Engenharia da universidade do P...
متن کاملStrain-induced Texture Development in the Magnesium Alloy Az31
Magnesium alloys are receiving increasing attention as a structural material in vehicles to reduce weight and increase fuel economy. Understanding the formability of lightweight alloys is one key to their successful introduction in vehicles. We present results of X-Ray diffraction and electron back-scatter diffraction texture measurements in as-cast and uniaxially compressed AZ31 for a variety ...
متن کاملCorrosion behaviour of friction stir welded AZ61A magnesium alloy welds immersed in NaCl solutions
The extruded AZ61A magnesium alloy plates of 6 mm thickness were butt welded using friction stir welding (FSW) process. The corrosion behavior of the welds was evaluated by conducting immersion test in NaCl solution at different pH value, immersion time and chloride ion concentrations. An empirical relationship was established incorporating pH value, immersion time and chloride ion concentratio...
متن کاملMicrostructure Evolution and Shaping of Friction Stir Lap Welded Dissimilar Magnesium Alloy Joint
Friction stir lap welding (FSLW) experiment has been conducted on 3mm thick AZ80 extruded sheet and 2.3mm thick AZ31B rolled sheet. The influence of the shape of the taper thread mixing head on microstructure has been discussed. Pores forming, hooked defects, interface migration, tissue distribution have been analyzed. The organization of both sides of nugget zone (NZ) is arranged diagonally ab...
متن کاملOptimizing the Process Parameters of Friction Stir Welded Joint of Magnesium Alloy Az31b
This paper deals with Friction stir welding of AZ31B Mg alloy by using H13 Tool at different rotational speeds and welding speeds .Experiments were conducted according to L4 Orthogonal array which was suggested by Taguchi. Optimum parameters for optimum Tensile strength, Hardness and Ductility were found with the help of S/N ratios. Therefore optimization of input process parameter is required ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: MATERIALS TRANSACTIONS
سال: 2006
ISSN: 1345-9678,1347-5320
DOI: 10.2320/matertrans.47.1071