Microstructural Design for High-Strain-Rate Superplastic Oxide Ceramics
نویسندگان
چکیده
منابع مشابه
Microstructural Design of Toughened Ceramics
The fracture toughness of ceramics can be improved by the incorporation of a variety of discontinuous, elastic reinforcing phases that generate a crack-bridging zone. Recent models of toughening by crack-bridging processes are discussed and used to describe the behavior observed in whisker-reinforced ceramics. The toughening response in ceramics reinforced with other types of discontinuous rein...
متن کاملDevelopment of Superplastic Structural Ceramics
Superplastic structural ceramics (Y-TZP, A1203, Si3N4, and their composites) that can withstand biaxial stretching to large strains have been developed recently. Microstructural design of these ceramics first requires an ultrafine grain size that is stable against coarsening during sintering and deformation. A low sintering temperature is a necessary, but not a sufficient, condition for achievi...
متن کاملMicrostructural design of platelet reinforced ceramics
Platelet reinforcement can increase the fracture toughness of ceramics. However, the responsible mechanisms are still not clearly understood. In this paper we examine the role of residual stresses due to thermal expansion mismatch. The residual stress distribution can be calculated using the effective-field approximation for ellipsoidal inclusions. The three main toughening mechanisms (crack de...
متن کاملHIGH TEMPERATURE ELASTIC STRAIN EVOLUTION IN Si3N4-BASED CERAMICS
Tension experiments in vacuum were performed on a monolithic Si3N4 sample at 1375°C and a 20Vol% SiCp-Si3N4 composite sample at 1400°C using the new SMARTS diffractometer at the Los Alamos Neutron Science Center. The deep penetration of neutrons facilitated these in-situ studies. In particular, the hkl-dependent strains were measured and the results interpreted by Eshelby-based modeling for the...
متن کاملHigh Strain Ra 33 . High Strain Rate and Impact Experiments
Experimental techniques for high-strain-rate measurements and for the study of impactrelated problems are described. An approach to classifying these experimental techniques is presented, and the state-of-the-art is briefly described. An in-depth description of the basis for high-strain-rate experiments is presented, with an emphasis on the development of a range of strain rates and a range of ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Ceramic Society of Japan
سال: 2005
ISSN: 0914-5400,1882-1022
DOI: 10.2109/jcersj.113.191