Microstructural and mechanical properties of Al-4.5wt% Cu reinforced with alumina nanoparticles by stir casting method
نویسندگان
چکیده
منابع مشابه
INVESTIGATION OF MICROSTRUCTURAL AND MECHANICAL PROPERTIES OF 7075 AL ALLOYPREPARED BY SIMA METHOD
The microstructure and mechanical properties of 7075 wrought aluminum alloy produced by strain induced melt activation (SIMA) route were investigated.Also liquid volume fraction measurement was studied by three procedures. Remelting process was carried out in the range of 560 to 610 °C for 20 min holding. The microstructure in the semi-solid state consists of fine spherical solid grains surroun...
متن کاملImproving of Microstructure and Mechanical Properties of Al-A356 Alloy with Compo-Casting Method
Aluminum/alumina composites are used in automotive and aerospace industries due to their low density and good mechanical strength. In this research, the effect of mechanical stirring of slurry in liquid-solid phase temperature and injection of alumina powder with inert gas (Ar) on microstructure and mechanical properties of Al-A356 alloy is investigated. In order to improve of the wettability a...
متن کاملcontrol of the optical properties of nanoparticles by laser fields
در این پایان نامه، درهمتنیدگی بین یک سیستم نقطه کوانتومی دوگانه(مولکول نقطه کوانتومی) و میدان مورد مطالعه قرار گرفته است. از آنتروپی ون نیومن به عنوان ابزاری برای بررسی درهمتنیدگی بین اتم و میدان استفاده شده و تاثیر پارامترهای مختلف، نظیر تونل زنی(که توسط تغییر ولتاژ ایجاد می شود)، شدت میدان و نسبت دو گسیل خودبخودی بر رفتار درجه درهمتنیدگی سیستم بررسی شده اشت.با تغییر هر یک از این پارامترها، در...
15 صفحه اولStudying the Mechanical and Thermal Properties of Polymer Nanocomposites Reinforced with Montmorillonite Nanoparticles Using Micromechanics Method
In this study, the mechanical and thermal behavior of the nano-reinforced polymer composite reinforced by Montmorillonite (MMT) nanoparticles is investigated. Due to low cost of computations, the 3D representative volume elements (RVE) method is utilized using ABAQUS finite element commercial software. Low density poly ethylene (LDPE) and MMT are used as matrix and nanoparticle material, respec...
متن کاملOptimization of Microstructure and Mechanical Properties of Al-A360 Produced by Semi-Solid Casting
Semi-Solid Casting (SSM) is a new process that could produce globular structures with mechanical properties. The cooling slope method (CLM) is a one of this process that was employed to produce the A360 feedstock. In this method, The dendritic primary phase in the conventionally cast A356 alloy has transformed into a non-dendritic one. In this paper, The molten alloy with the temperature (PT) o...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal of Minerals, Metallurgy, and Materials
سال: 2013
ISSN: 1674-4799,1869-103X
DOI: 10.1007/s12613-013-0824-2