Micromachining imposed subsurface plastic deformation in single-crystal aluminum
نویسندگان
چکیده
منابع مشابه
Nanoscale anisotropic plastic deformation in single crystal aragonite.
The nanoscale anisotropic elastic-plastic behavior of single-crystal aragonite is studied using nanoindentation and tapping mode atomic force microscopy imaging. Force-depth curves coaxial to the axis exhibited load plateaus indicative of dislocation nucleation events. Plasticity on distinct slip systems was evident in residual topographic impressions where four pileup lobes were present after ...
متن کاملNanoscale anisotropic plastic deformation in single crystal GaN
Elasto-plastic mechanical deformation behaviors of c-plane (0001) and nonpolar GaN single crystals are studied using nanoindentation, cathodoluminescence, and transmission electron microscopy. Nanoindentation tests show that c-plane GaN is less susceptible to plastic deformation and has higher hardness and Young's modulus than the nonpolar GaN. Cathodoluminescence and transmission electron micr...
متن کاملFemtosecond Laser Micromachining of Single-crystal Superalloys
Investigations on femtosecond laser micromachining of single crystal superalloys with and without plasma-sprayed thermal barrier coatings were conducted under laser fluences ranging from 0.1 J/cm up to 160 J/cm. Micromachining was carried out in air using a titanium:sapphire laser system ( = 780 nm) operating at a repetition rate of 1 kHz and delivering individual pulses of ~150 fs duration. Th...
متن کاملModelling plastic deformation in a single-crystal nickel-based superalloy using discrete dislocation dynamics
Background: Nickel-based superalloys are usually exposed to high static or cyclic loads in non-ambient environment, so a reliable prediction of their mechanical properties, especially plastic deformation, at elevated temperature is essential for improved damage-tolerance assessment of components. Methods: In this paper, plastic deformation in a single-crystal nickel-based superalloy CMSX4 at el...
متن کاملPlastic deformation of CoO single crystals
2014 Constant strain rate compressions along 001 > have been performed on CoO single crystals (03B5 ~ 6 x 10-5 s-1). Yield stresses and work hardening rates have been measured between 77 K and 1 400 K; CoO is very strong when compared to similar compounds. Vickers indentations have been performed on { 100 }, { 110 } and { 111 } faces around the Néel temperature, i.e. between 0 °C and 40 °C...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Materials Characterization
سال: 2021
ISSN: 1044-5803
DOI: 10.1016/j.matchar.2020.110747