Micromachined chip-scale plasma light source
نویسندگان
چکیده
منابع مشابه
Micromachined analyzers on a silicon chip.
For an example of a silicon-based micromachined analyzer, we describe a combined PO2, PCO2, and pH sensor designed for extracorporeal blood gas monitoring. The clinically well-accepted amperometric (PO2) and potentiometric (PCO2, pH) sensing principles are used, realized in a planar and miniaturized form on a single silicon chip (6 x 22 mm). The transducer part of the chip is fabricated by stan...
متن کاملMicromachined calibration chip with heat source and temperature sensors for Scanning Thermal Metrology (SThM)
The monitoring of heat flux is becoming more and more critical for many technologies approaching nanometric dimensions. Scanning Thermal Microscopy (SThM) is one of the tools available for thermal measurement at the nanoscale. This measurement technics needs calibration samples. Therefore, micro-hotplates made of platinum heater suspended on thin silicon nitride (SiN) membranes were fabricated ...
متن کاملMeter Scale Plasma Source For Plasma Wakefield Experiments
High accelerating gradients generated by a high density electron beam moving through plasma has been used to double the energy of the SLAC electron beam [1]. During that experiment, the electron current density was high enough to generate its own plasma without significant head erosion. In the newly commissioned FACET facility at SLAC, the peak current will be lower and without pre-ionization, ...
متن کاملLight well: a tunable free-electron light source on a chip.
The passage of a free-electron beam through a nanohole in a periodically layered metal-dielectric structure creates a new type of tunable, nanoscale radiation source--a "light well". In the reported demonstration, tunable light is generated at an intensity of approximately 200 W/cm(2) as electrons with energies in the 20-40 keV range are injected into gold-silica well structures with a lateral ...
متن کاملCMOS micromachined grippers with on-chip optical detection
This paper presents the design, fabrication and characterization of CMOS (complementary metal oxide semiconductor) micromachined grippers with on-chip photo detectors placed beneath the gripping sites. The fabrication features a combination of metal wet etch and sacrificial polysilicon etch for structural release. The fabricated microstructure contains metal and dielectric layers, plus a polysi...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Sensors and Actuators A: Physical
سال: 2009
ISSN: 0924-4247
DOI: 10.1016/j.sna.2008.05.028