Microcutting with Reduced Cutting Force by Electrolysis.
نویسندگان
چکیده
منابع مشابه
Investigating Flank Wear and Cutting Force on Hard Steels by CBN Cutting Tool by Turning
In this research work a series of tests were conducted in order to determine flank wear and cutting force FY on hard AISI 440 C martensitic stainless steel and SCM 440 alloy steels. The operating parameters are cutting speed, feed rate and a constant depth of cut to investigate the flank wear and cutting force. No cutting fluid was used during the turning process. The cutting tool used was CBN ...
متن کاملThe Impact of Cutting Tool Materials on Cutting Force
A judicious choice of insert material, tool geometry and cutting conditions can make hard turning produce better surfaces than grinding. In the present study, an attempt has been made to investigate the effect of cutting tool materials on cutting forces (feed force, thrust force and cutting force) in finish hard turning of AISI D2 cold work tool steel. In conclusion of the results obtained with...
متن کاملEffects of Friction and Cutting Speed on Cutting Force
Observations are made regarding the influence of cutting speed and friction on cutting force by way of finite element modeling. Simulations are validated by comparison of cutting forces and chip morphologies for the Al6061-T6. Analysis of cutting forces over a wide range of cutting conditions suggests an important role of the secondary shear zone in the decrease of cutting force as a function o...
متن کاملthe effect of tool rake angle and cutting speed on cutting force during broaching process by using finite element modeling
0
متن کاملPurification of Floodwater by Electrolysis
An adequate supply of pure water is absolutely essential to human existence. During floods, water is available in adequate quantity, but the quality is often not suitable for drinking or cooking purposes. The goal of the study was to develop an easier, cheaper and faster technique of water purification. Oxygen ions are well known for their high reactivity. An attempt has been made to use oxygen...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of The Japan Society of Electrical Machining Engineers
سال: 1999
ISSN: 1881-0888,0387-754X
DOI: 10.2526/jseme.33.74_24