Micro-scale Strain Distribution in Hot-worked Duplex Stainless Steel
نویسندگان
چکیده
منابع مشابه
Relaxation Peaks of Cold Worked 304l Stainless Steel
In this investigation internal friction of cold worked 304L austenitic stainless steel was measured and the new peaks (PlIP2,P3) were found. The height of those peaks increased with cold work degree. The temperature of the main peak P3 was 33513340K at the frequency of -1,000Hz. The activation energies and frequency factors were obtained from peak shift. The values were 0.4evl 0.4evl 0.6ev and ...
متن کاملStudy on Static Recrystallization Process in Duplex Stainless Steel 2205
Steel 2205 is one of the most famous duplex stainless steels. The microstructure of this steel composed of ferrite and austenite in similar amount. Therefore, in order to improve mechanical properties through microstructure, thermo mechanical processes such as controlled hot rolling and forging should be applied. It is not possible to employ the usual heat treatment. It shows the importance of ...
متن کاملDeformation Characteristic and Constitutive Modeling of 2707 Hyper Duplex Stainless Steel under Hot Compression
Hot deformation behavior and microstructure evolution of 2707 hyper duplex stainless steel (HDSS) were investigated through hot compression tests in the temperature range of 900–1250 ◦C and strain rate range of 0.01–10 s−1. The results showed that the flow behavior strongly depended on strain rate and temperature, and flow stress increased with increasing strain rate and decreasing temperature....
متن کاملCrystallography of Widmanstätten austenite in duplex stainless steel weld metal
Two kinds of austenite grow from d-ferrite during the cooling of the duplex stainless steel weld deposits studied here, Widmanstätten plates and allotriomorphs which precipitate at d–d grain boundaries. It is found using microtexture measurements that the preferred crystallographic orientation of the Widmanstätten austenite can be estimated using established theory if it is assumed that there i...
متن کاملKinetics of Sigma Phase Formation In a Duplex Stainless Steel
This work determines the kinetics of sigma phase formation in UNS S31803 Duplex Stainless Steel (DSS), describing the phase transformations that occur in isothermal aging between 700 and 900 °C for time periods up to 1032 hours, allowing the determination of the Time-Temperature-Precipitation (TTP) diagram for sigma phase and proposing a model to predict the kinetics of sigma phase formation us...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: steel research international
سال: 2005
ISSN: 1611-3683
DOI: 10.1002/srin.200505985