Micro-propulsion based on vacuum arcs
نویسندگان
چکیده
منابع مشابه
Modular Micro Propulsion System
M.C. Louwerse, H.V. Jansen, J.L.P.A. Moerel, H.M. Sanders, B.T.C. Zandbergen Dept. of Transducer Science & Technology, University of Twente, P.O. Box 217, 7500 AE Enschede, The Netherlands TNO Defence, Security and Safety, P.O. Box 45, 2280 AA Rijswijk, The Netherlands Dept. of Earth Observation and Space Systems, Delft University of Technology, P.O. Box 5058, 2600 GB Delft, The Netherlands ema...
متن کاملAnalytic and computational studies on micro-propulsion and micro-detonics
Based on a general theory of detonation waves with an embedded sonic locus that we have previously developed, we carry out asymptotic analysis of weakly curved slowly varying detonation waves and show that the theory predicts the phenomenon of detonation ignition and failure. The analysis is not restricted to near ChapmanJouguet detonation speeds and is capable of predicting quasi-steady, norma...
متن کاملOn Thermonuclear Micro-Bomb Propulsion for Fast Interplanetary Missions
To reduce the radiation hazard for manned missions to Mars and beyond, a high specific impulse-high thrust system is needed, with a nuclear bomb propulsion system the preferred candidate. The propulsion with small fission bombs is excluded because the critical mass requirement leads to extravagant small fission burn up rates. This leaves open the propulsion with non-fission ignited thermonuclea...
متن کاملNozzle Fabrication for Micro Propulsion of a Micro Satellite
⎯ To enable formation flying of micro satellites, small sized propulsion systems are required. Our research focuses on the miniaturization of a feeding and thruster system by means of micro system technology (MST). Three fabrication methods have been investigated to make a conical converging-diverging nozzle. These methods are reactive ion etching, femtosecond laser machining (FLM) and a combin...
متن کاملThe Development of a Micro-Fabricated CNT-Based Neutralizer for Micro-Propulsion Applications
This paper reports the preliminary development of a microand nano-fabricated carbon nanotube (CNT) –based electron source intended for micro-propulsion applications. The paper proposes a device that implements a trade-off between microfabrication complexity and performance using a 3D packaging technology to minimize interception and decouple the process flows of the grid and the emitter array. ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Applied Physics
سال: 2019
ISSN: 0021-8979,1089-7550
DOI: 10.1063/1.5081096