Micro-injection moulding of polymer microfluidic devices

Micro-Injection Moulding of Polymer Microfluidic Devices

* Building 56, Cranfield University, Wharley End, Cranfield, Bedfordshire, MK43 0AL, UK. Tel: +44 (0)1234 750111 ext: 2513; E-mail: [email protected] a Building 56, Cranfield University, Wharley End, Cranfield, Bedfordshire, MK43 0AL, UK. Fax: +44 (0)1234 751346; Tel: +44 (0)1234 750111 ext: 2379; E-mail: [email protected] b Building 61, Cranfield University, Wharley End, Cranfield...

Strategies for high quality injection moulding of polymer nanopillars

Excimer laser fabrication of polymer microfluidic devices

Silicon has been a primary material for fabrication of microelectromechanical systems ~microfluidic devices in MEMS! for several decades. This is due to the fact that the MEMS techniques were derived from those used for microfabrication in the semiconductor industry. These techniques are well developed, and can be readily applied for silicon based MEMS fabrication. Nowadays, alternative manufac...

Macro-to-micro interfaces for microfluidic devices.

Since the concept of miniaturized total analysis systems (microTAS) was invented, a great number of microfluidic devices have been demonstrated for a variety of applications. However, an important hurdle that still needs to be cleared is the connection of a microfluidic device with the rest of the world, which is often referred to as the macro-to-micro interface, interconnect, or world-to-chip ...

Microfluidic Devices for Insect Micro-Air-Vehicles

This work describes the intimate fusion of microsystems and physiology though the implantation of a microfluidic device into living insects. Specifically, we focus on the control of Manduca sexta moth flight activity using an implanted, low power electrokinetic drug delivery device. This effort is a critical component in our development of “Insect Micro-Air-Vehicles” which aim to fuse nanodevic...