Micro-fabrication on Glass Surface Using Micro-indentation and Wet Etching Process
نویسندگان
چکیده
منابع مشابه
Two-step Glass Wet-etching for Micro-fluidic Devices
In this paper a two-step glass wet-etching process is presented. This process allows the fabrication of well-defined shallow recesses (typically 1-40μm) together with deep trenches or waferthrough holes (100-500μm) in the same glass wafer. The etching solutions and the masking materials used are described for the three glass types frequently used in sensor fabrication. This process is developed...
متن کاملSilicon Micro/Nanomechanical Device Fabrication Based on Focused Ion Beam Surface Modification and KOH Etching
Selective Ga + ion implantation and miring by focused ion beam exposure and subsequent wet chemical etching is used to fabricate micro/nanomechanical elements in Si. Freestanding elements with a ~ 30 nm membrane thickness are made by controlled selective underetching between unexposed and exposed areas. Ultrahigh-frequency cantilever beams have been made with resonances in the tens of MHz range...
متن کاملAnisotropic Dry Etching ( RIE ) for Micro and Nanogap Fabrication
The main objective of this research is to develop a micro and nanogap structure using dry anisotropic etching –Reactive Ion EtchingRIE. Amorphous silicon material is used in the micro and nanogap structure and gold as electrode. The fabrication processes of the micro and nanostructure are based on conventional photolithography, wet etching for the Al pattern and wet etching for a-Si pattern usi...
متن کاملFabrication of Wireless Micro Pressure Sensor Using the CMOS Process
In this study, we fabricated a wireless micro FET (field effect transistor) pressure sensor based on the commercial CMOS (complementary metal oxide semiconductor) process and a post-process. The wireless micro pressure sensor is composed of a FET pressure sensor, an oscillator, an amplifier and an antenna. The oscillator is adopted to generate an ac signal, and the amplifier is used to amplify ...
متن کاملMicro-layered-photolithography for Micro- Fabrication and Micro-molding
A novel process based on the principle of layered photolithography has been proposed and tested for making three-dimensional micro-structures. An experimental setup was designed and built for doing experiments on this micro-fabrication process. An ultraviolet (UV) excimer laser at the wavelength of 248 nm was used as the light source and a single piece of photo-mask carrying a series of two dim...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of The Adhesion Society of Japan
سال: 2009
ISSN: 0916-4812,2187-4816
DOI: 10.11618/adhesion.45.352