Micro-Fabrication of Ferromagnetic Tunnel Junctions Using Ar Ion Milling.
نویسندگان
چکیده
منابع مشابه
Noise properties of ferromagnetic tunnel junctions
We report measurements of voltage fluctuations in magnetic tunnel junctions which exhibit both high and low magnetoresistance ~MR!. The voltage noise power normalized to the square of the junction bias voltage was 10/Hz at a frequency of 1 Hz in a high MR junction. Low MR junctions had significantly higher noise power at 1 Hz and the origin of the noise was not magnetic. In these junctions, ran...
متن کاملFabrication of Microfluidic Channel Using Micro End Milling and Micro Electrical Discharge Milling
This paper discusses the fabrication of microfluidic channels using micro end milling and micro electrical discharge (ED) milling on metals and polymers. The width of the microchannels fabricated by micro end milling was 100-800 μm with 1-2 aspect ratio. The average surface roughness values were 100-200 nm and 80-120 nm on metals and polymers respectively. The end milling was found to form more...
متن کاملDielectric breakdown of ferromagnetic tunnel junctions
• A submitted manuscript is the author's version of the article upon submission and before peer-review. There can be important differences between the submitted version and the official published version of record. People interested in the research are advised to contact the author for the final version of the publication, or visit the DOI to the publisher's website. • The final author version ...
متن کاملProperties of tunnel Josephson junctions with a ferromagnetic interlayer
A. S. Vasenko,1,2,* A. A. Golubov,1 M. Yu. Kupriyanov,3 and M. Weides4 1Faculty of Science and Technology and MESA+ Institute for Nanotechnology, University of Twente, 7500 AE Enschede, The Netherlands 2Department of Physics, Moscow State University, Moscow 119992, Russia 3Nuclear Physics Institute, Moscow State University, Moscow 119992, Russia 4Center of Nanoelectronic Systems for Information...
متن کاملHighly charged ion (HCI) modified tunnel junctions
The neutralization energy carried by highly charged ions (HCIs) provides an alternative method for localizing energy on a target’s surface, producing features and modifying surfaces with fluences and kinetic energy damage that are negligible compared to singly ionized atoms. Since each HCI can deposit an enormous amount of energy into a small volume of the surface (e.g., Xe delivers 51 keV of n...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Magnetics Society of Japan
سال: 1999
ISSN: 0285-0192
DOI: 10.3379/jmsjmag.23.1305