Method of immediately cutting process stoppage
نویسندگان
چکیده
منابع مشابه
Evaluation of Disc Cutter Performance in Rock Cutting Process Using 3D Finite Element Method
Today, numerical simulation can be used as a suitable tool to measure large quantities that are very expensive and, in some cases, impossible to measure. One of the important issues in predicting rock mass boreability in excavation with full face tunnel boring machines is estimating the discchr('39')s forces for rock cutting. For this purpose, the linear cutting test is employed. However, limi...
متن کاملWastewater Treatment of Stone Cutting Industries by Coagulation Process
Background & Aims of the Study: The wastewater created as a result of stone cutting industries enters some pools for re-consumption so that its suspended solids settle by gravity. By taking to account the high volume of water and sludge, treatment of wastewater and removal of sludge cause many problems for stone cutting units. The objective of this study was to determine the quality of wast...
متن کاملExperimental Study of the Effect of Laser-Cutting Process Parameters on Heat Distribution and Cutting Edge Quality of Steel Sheets
This study aimed to evaluate Laser-cutting process of Mild Steel St37 sheets with two different thicknesses. In order to evaluate the quality of cutting edge and the depth of the area affected by the heat, several tests were conducted to determine the effect of parameters such as Laser power, Laser beam movement speed and pressure of axillary gas on the quality of cutting edge and the depth of ...
متن کاملInfluence of Water Cooling on Orthogonal Cutting Process of Ti-6Al-4V Using Smooth-Particle Hydrodynamics Method
Temperature control during the cutting process with different parameters such as cutting velocity and applying water cooling is essential to decrease the cutting force, increase the life of the cutting tool and decrease the machined surface temperature of work-piece. In this research, the temperature of machined surface and the chip-tool interface in orthogonal cutting process of Ti-6Al-4V were...
متن کاملChaos in a Cutting Process
The dynamics of the cutting process are investigated. Using the increase of cutting depth as a control parameter, two diierent cutting regimes are observed. In the rst regime, which is observed at small cutting depths, complex, high-dimensional dynamics occur. In the second cutting regime, observed for deeper cuts, low dimensional dynamics are typical. The second cutting regime is usually ident...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Manufacturing Technology
سال: 2014
ISSN: 1213-2489,1213-2489
DOI: 10.21062/ujep/x.2014/a/1213-2489/mt/14/2/245