Metallurgical Characterization of API X65 Steel Joint Welded by MIG Welding Process with Axial Magnetic Field
نویسندگان
چکیده
منابع مشابه
Research on Thermal Process of MIG Welding of Aluminum Alloy with Longitudinal Magnetic Field
In order to study MIG welding process of aluminum alloy with longitudinal magnetic field, thermal efficiency with longitudinal magnetic field was analyzed, as well as softening behavior of heat-affected zone (HAZ) and base metal were investigated. The results showed that under the action of longitudinal magnetic field, welding current decreased and resultingly total heat input reduced as the ex...
متن کاملEffect of Heat Input on Microstructural and Mechanical Properties of AISI 304 Welded Joint Via MIG Welding
In this experimental work, AISI 304 was welded via metal inert gas (MIG) welding process with Argon (Ar) as shielding gas. In the present study, AISI 304 was subjected to different heat input using a standard 308L electrode. Weld quality i.e. ultimate tensile strength, toughness, microhardness, and microstructure of AISI 304 were examined. Microstructures of welded joints were studied using sca...
متن کاملEffect of Mig Welding Input Process Parameters on Weld Bead Geometry on Hsla Steel
The various welding parameters such as welding speed, voltage and gas flow rate were varied on HSLA steel and the effects of these parameters on weld bead geometry such as penetration, width & height have been studied. Mathematical equations have been developed using factorial technique. And the result of various effects are shown in tables. (Numerical Values). INTRODUCTION Wide variety of stee...
متن کاملInvestigating the Effect of Optimum Welding Parameters on the Microstructural and Mechanical Properties of St37 Steel and 316L Stainless Steel Welded by the Friction Stir Welding Process
In this research, St37 and 316L steel sheets were welded using friction stir welding (FSW) process and effective parameters such as the rotational speed, linear speed of the tool, pin diameter, and their appropriate values were studied. The microstructure, hardness, and strength of the different welding regions were investigated. It was observed that in the stir zone (SZ), a mechanical operatio...
متن کاملAn Investigation of the Microstructure of an Intermetallic Layer in Welding Aluminum Alloys to Steel by MIG Process
Butt joints of A5052 aluminum alloy and SS400 steel, with a new type of chamfered edge, are welded by means of metal inert gas welding and ER4043 Al-Si filler metal. The microhardness and microstructure of the joint are investigated. An intermetallic layer is found on the surface of the welding seam and SS400 steel sheet. The hardness of the intermetallic layer is examined using the Vickers har...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Materials Research
سال: 2017
ISSN: 1980-5373,1516-1439
DOI: 10.1590/1980-5373-mr-2016-0182