Metallurgical and formability investigations on Al 8011 alloy upon form drilling
نویسندگان
چکیده
منابع مشابه
The Metallurgical Database of Aladin - an Alloy Design System
Aladin is an expert system that aids metallurgists in the design of new aluminum alloys. Declarative structured representations in the form of schemata are used for metallurgical data and concepts. The representation is very general, the goal has been to create a representation for all knowledge about aluminum alloys and metallurgy relevant to the design process. This article gives an overview ...
متن کاملEffect of Al–5Ti–C Master Alloy on the Microstructure and Mechanical Properties of Hypereutectic Al–20%Si Alloy
Al-5Ti-C master alloy was prepared and used to modify hypereutectic Al-20%Si alloy. The microstructure evolution and mechanical properties of hypereutectic Al-20%Si alloy with Al-5Ti-C master alloy additions (0, 0.4, 0.6, 1.0, 1.6 and 2.0 wt%) were investigated. The results show that, Al-5Ti-C master alloy (0.6 wt%, 10 min) can significantly refine both eutectic and primary Si of hypereutectic ...
متن کاملNumerical and Experimental Investigations on Springback of U-bending of DP600 Steel Alloy Sheet
The most prominent feature of sheet material forming process is an elastic recovery phenomenon during unloading which leads to springback and side wall curl. Therefore evaluation of springback and side wall curl is mandatory for production of precise products. In this paper, the effects of some parameters such as friction coefficient, sheet thickness, yield strength of sheet and blank-holder fo...
متن کاملNumerical Investigations on the Effect of Pulsating Pressure on Improvement of Formability in Hydroforming of Bent Tube by FEM
In this paper, hydroforming process of bent tubes in T-shaped die is studied for pulsating and linear pressure paths by the finite element method. Forming Limit Diagrams (FLDs) and thickness distribution curves are used to investigate the effect of pulsating pressure on hydroforming process. In addition, the obtained numerical results are compared with experimental results of hydroforming of st...
متن کاملEFFECTS OF Al-5TI-1B MASTER ALLOY AND HEAT TREATMENT ON THE MICROSTRUCTURE AND DRY SLIDING WEAR BEHAVIOR OF AN Al-12Zn-3Mg-2.5Cu ALLOY
In this study the effect of Al–5Ti–1B grain refiner on the structural characteristics and wear properties of Al–12Zn–3Mg–2.5Cu alloy was investigated. The optimum amount for Ti containing grain refiners was selected as 2 wt.%. T6 heat treatment, (i.e. heating at 460 °C for 1 h before water quenching to room temperature and then aging at 120 °C for 24 h) was applied for all specimens before wear...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: SN Applied Sciences
سال: 2020
ISSN: 2523-3963,2523-3971
DOI: 10.1007/s42452-020-2152-2