Metallizing on Cyclo Olefin Polymer Film Using UV Irradiation as a Surface Modification
نویسندگان
چکیده
منابع مشابه
Surface Wettability Modification of Cyclic Olefin Polymer by Direct Femtosecond Laser Irradiation
The effect of laser irradiation on surface wettability of cyclic olefin polymer (COP) was investigated. Under different laser parameters, a superhydrophilic or a superhydrophobic COP surface with a water contact angle (WCA) of almost 0° or 163°, respectively, could be achieved by direct femtosecond laser irradiation. The laser power deposition rate (PDR) was found to be a key factor on the wett...
متن کاملSurface Modification of Polymer Materials Induced by Laser Irradiation
We report on the surface modification effects using allyl‐diglycol CR39 polymer induced by laser irradiation at 157 nm F2 laser (VUV) and 248 nm KrF laser. The motivation is to investigate the ablation effects on this polymer in optical waveguides application the ablation effects on this polymer in optical waveguides. Fabrication of waveguides has been observed using continuous wave (CW) at 244...
متن کاملModification of Montmorillonite and Prediction of Polymer/Clay Affinity Using Surface Properties and Lattice Model
"> Sodium montmorillonite (Na-MMT) was organically modified using 11- aminoundecanoic acid (AUA) and methacryloxyethyltrimethylammonium chloride <span style="font-size: 9pt; color: #000000; font-style: n...
متن کاملLow-temperature Polymer Bonding Using Surface Hydrophilic Treatment for Chemical/bio Microchips
Polymer materials have been used for electronic, optical and bio micro/nano devices. Polymer device fabrication technologies based on replication methods including hot embossing (Becker & Heim, 2000; Park et al., 2003; Shinohara et al., 2007b), injection molding (Becker et al., 1986; Svedberg et al., 2003), ultraviolet (UV) imprinting (Haisma et al., 1996; Kawaguchi et al., 2007; Shinohara et a...
متن کاملSurface modification of starch based biomaterials by oxygen plasma or UV-irradiation.
Radiation is widely used in biomaterials science for surface modification and sterilization. Herein, we describe the use of plasma and UV-irradiation to improve the biocompatibility of different starch-based blends in terms of cell adhesion and proliferation. Physical and chemical changes, introduced by the used methods, were evaluated by complementary techniques for surface analysis such as sc...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Japan Institute of Electronics Packaging
سال: 2010
ISSN: 1343-9677,1884-121X
DOI: 10.5104/jiep.13.447