Metallic Plate Buckling As a Low Adhesion Mechanism for Durable and Scalable Icephobic Surface Design (Adv. Mater. Interfaces 1/2022)

Designing durable icephobic surfaces.

Ice accretion has a negative impact on critical infrastructure, as well as a range of commercial and residential activities. Icephobic surfaces are defined by an ice adhesion strength τice < 100 kPa. However, the passive removal of ice requires much lower values of τice, such as on airplane wings or power lines (τice < 20 kPa). Such low τice values are scarcely reported, and robust coatings tha...

Durable and scalable icephobic surfaces: similarities and distinctions from superhydrophobic surfaces.

Formation, adhesion, and accumulation of ice, snow, frost, glaze, rime, or their mixtures can cause severe problems for solar panels, wind turbines, aircrafts, heat pumps, power lines, telecommunication equipment, and submarines. These problems can decrease efficiency in power generation, increase energy consumption, result in mechanical and/or electrical failure, and generate safety hazards. T...

Tissue morphogenesis: a surface buckling mechanism.

Surface patterns can emerge during growth of anisotropic tissues because of surface buckling. This morphogenetic scenario is examined in the present paper based on a simple phenomenological theory of tissue growth. In particular, we show that constrained growth can lead to tissue compression, which in turn may result in surface buckling of the tissue. The latter means the appearance of wavy pat...

Metamaterials: Snapping Mechanical Metamaterials under Tension (Adv. Mater. 39/2015).

By exploiting snap-through instabilities, D. Pasini and co-workers design a damage-tolerant mechanical metamaterial that snaps sequentially under tension, thereby accommodating a very large deformation up to 150%. On page 5931, they describe how the nonlinear mechanical response of the metamaterial can be robustly programmed by tuning the architecture of its unit cell.

The Buckling of a Prestressed Circular Plate*