Metallic glass nanotube arrays: Preparation and surface characterizations
نویسندگان
چکیده
منابع مشابه
Nanotube surface arrays: weaving, bending, and assembling on patterned silicon.
We report the fabrication of ordered arrays of oriented and bent carbon nanotube on a patterned silicon surface with a micron scale spacing extending over millimeter size surface areas. We suggest that the patterning is controlled by the hydrodynamic behavior of a fluid front and orientation and bending mechanisms are facilitated by the pinned carbon nanotubes trapped by the liquid-solid-vapor ...
متن کاملPressure effects on Ca60Al40 metallic glass superconductors
Theoretical computation of the pressure dependence superconducting state parameters of binary Ca60Al40 is reported using model potential formalism. Explicit expressions have been derived for the volume dependence of the electron–phonon coupling strength λ and the Coulomb pseudopotential μ* considering the variation of Fermi momentum KF and Debye temperature ӨD with volume. Well known Ashcroft’s...
متن کاملSurface microstructure of Zr41.25Ti13.75Cu12.5Ni10.0Be22.5, a bulk metallic glass
The surface of Zr41.25Ti13.75Cu12.5Ni10.0Be22.5, a bulk metallic glass prepared by RF induction melting, has been imaged using atomic force microscopy. The untreated surfaces were very smooth; features were no higher than 3 nm over a 10 3 10 mm region, comparable to many polished surfaces. Two types of microstructure were also observed; periodic striations forming either a striped or a checkere...
متن کاملSurface properties of vertically aligned carbon nanotube arrays
This study focuses on the structural changes of vertically aligned carbon nanotube (CNT) arrays while measuring their adhesive properties and wetting behaviour. CNT forests grown by chemical vapor deposition with a height of ~100 μm, an outer CNT diameter of ~10 nm and a density of the order of ~10 CNTs/cm show an average adhesion of 4 N/cm when pressed against a glass surface. The applied forc...
متن کاملSeparation of metallic and semiconducting single-walled carbon nanotube arrays by "scotch tape".
The dielectrophoretic (DEP) separation of metallic and semiconducting single-walled carbon nanotubes (SWNTs) has been investigated. DEP separation experiments were performed by following the previous reports and the modification of Raman spectra was confirmed. We then theoretically investigated the impact of the flow field on the dielectrophoretic separation. The electrothermal flow was found t...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Materials Today
سال: 2018
ISSN: 1369-7021
DOI: 10.1016/j.mattod.2017.10.007