Metal-Semiconductor-Metal Photodetector Fabricated on Thin Polysilicon Film
نویسندگان
چکیده
منابع مشابه
Metal-Semiconductor Interfaces in Thin-Film Transistors
The metal-semiconductor interface in thin-film transistors (TFTs) is one of the bottlenecks on the development of these devices. Although this interface does not play an active role in the transistor operation, a low-quality interface can be responsible for a low performance operation. In a-Si TFTs, a doped film can be used to improve this interface, however, in other TFT technologies, there is...
متن کاملMetal-semiconductor-metal ultraviolet photodetector based on GaN
A metal-semiconductor-metal (MSM) ultraviolet photodetector has been fabricated using unintentionally doped n-GaN films grown on sapphire substrates. Its dark current, photocurrent under the illumination with λ = 360 nm light, responsivity, and the dependence of responsivity on bias voltage were measured at room temperature. The dark current of the photodetector is 1.03 nA under 5 V bias, and i...
متن کاملFinite Element Simulation of Metal–Semiconductor–Metal Photodetector
LLE Review, Volume 119 154 Introduction Low-temperature–grown GaAs (LT-GaAs), deposited by molecular beam epitaxy, has been known for its ultrashort, subpicosecond photocarrier lifetime and relatively high carrier mobility. Therefore, in recent years LT-GaAs has been the material of choice for the fabrication of photonic devices such as photoconductive switches,1,2 both of the metal–semiconduct...
متن کاملQuantum dot-doped porous silicon metal–semiconductor metal photodetector
In this paper, we report on the enhancement of spectral photoresponsivity of porous silicon metal-semiconductor metal (PS-MSM) photodetector embedded with colloidal quantum dots (QDs) inside the pore layer. The detection efficiency of QDs/PS hybrid-MSM photodetector was enhanced by five times larger than that of the undoped PS-MSM photodetector. The bandgap alignment between PS (approximately 1...
متن کاملOptimum Metal-Semiconductor Contact for Cadmium Sulphide Thin Film
Activation Energy is an important feature in determining the formation of ohmic contact on a semiconducting material. Activation energy depends on workfunction of the semiconductor. Thus, there is a good co-relation between the ohmicity, activation energy and workfunction. In this work, Cadmium Sulphide (CdS) thin film of 2 μm thickness is the semiconducting material fabricated using Chemical V...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Korean Institute of Electrical and Electronic Material Engineers
سال: 2017
ISSN: 1226-7945
DOI: 10.4313/jkem.2017.30.5.276