Metal Forming by Underwater Wire Explosion : 1. An Analysis of Plastic Deformation of Circular Membranes Under Impulsive Loading
نویسندگان
چکیده
منابع مشابه
Prediction of Deformation of Circular Plates Subjected to Impulsive Loading Using GMDH-type Neural Network
In this paper, experimental responses of the clamped mild steel, copper, and aluminium circular plates are presented subjected to blast loading. The GMDH-type neural networks (Group Method of Data Handling) are then used for the modelling of the mid-point deflection thickness ratio of the circular plates using those experimental results. The aim of such modelling is to show how the mid-point de...
متن کاملNumerical Analysis of Severe Plastic Deformation by High Pressure Torsion
High-pressure torsion (HPT) is a metal processing method in which the sample is subjected to a very high plastic shear deformation. This process can produce exceptional levels of grain refinement, and provides a corresponding improvement in mechanical properties. To investigate the stress and strain distribution due to HPT process finite element simulation were conducted to investigate effectiv...
متن کاملExtreme water state produced by underwater wire-array electrical explosion
The generation of an extreme water state 130 GPa, 5000 K, and 3.4 g /cm3 which is characterized as dense plasma at the axis of a converging shock wave is reported. A 4 kJ pulse generator was used to explode a 40 Cu-wire array, generating a cylindrical shock wave. The measured shock wave trajectory and energy deposited into the water flow were used in hydrodynamic simulations coupled with the eq...
متن کاملForming of Multi layer Sheet Metal by Drawing Process: an Analysis and FEM Simulation
In this paper, the drawing process of multi-layer sheet metal through wedge shaped die has been analyzed using stream function and upper bound method. Typically a sandwich sheet contains three layers of metal, where the outer layers are of the same thickness and material and different from those of the inner layer. In this study, a new deformation model has been introduced in which inlet and ou...
متن کاملEvaluation of Plastic Deformation During Metal Forming by Using Lode Parameter
In the present research, the relationship between the strain increment and Lode parameter was obtained by using Lode parameter and Levy-Mises equation. The quantitative relation between different strain increments was presented and the relationship between plastic deformation types and Lode parameter was demonstrated. The relations between plastic deformation types and stress states were reveal...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Bulletin of JSME
سال: 1979
ISSN: 0021-3764,1881-1426
DOI: 10.1299/jsme1958.22.271