Meta-metallic coils and resonators: Methods for high Q-value resonant geometries
نویسندگان
چکیده
منابع مشابه
HTS High Q Resonant Controller
High Tc superconductor (HTS) technology has been used to develop an advanced high Q resonant circuit and its devices. With a HTS, a very high Q circuit can be achieved; consequently special aspects such as high voltage generation and high current control can be theoretically and practically realized. Theoretical study has been carried out, as well as a practical approach has been made for the c...
متن کاملHigh-Q Low-Impedance MEMS Resonators
Permission to make digital or hard copies of all or part of this work for personal or classroom use is granted without fee provided that copies are not made or distributed for profit or commercial advantage and that copies bear this notice and the full citation on the first page. To copy otherwise, to republish, to post on servers or to redistribute to lists, requires prior specific permission....
متن کاملMicro-Molded High Q Polymer Resonators for Optical Loss Determination
Replica molding of ultra-high-Q toroidal microresonators can produce polymer microresonators with material-limited quality factors (Q). This was demonstrated previously using polymers which cure thermally. In this work, high Q polymer microresonators were fabricated using the replica molding technique from previously uncharacterized polymers which require either a thermal or UV cure. The qualit...
متن کاملHigh-Q MEMS Resonators for Laser Beam Scanning Displays
This paper reports on design, fabrication and characterization of high-Q MEMS resonators to be used in optical applications like laser displays and LIDAR range sensors. Stacked vertical comb drives for electrostatic actuation of single-axis scanners and biaxial MEMS mirrors were realized in a dual layer polysilicon SOI process. High Q-factors up to 145,000 have been achieved applying wafer leve...
متن کاملQ measurement and simulation for RF coils
Introduction: A widely used figure of merit in radiofrequency (RF) coil construction and testing is the Q or ‘quality factor.’ Q is a measure of the spectral selectivity of the coil, Q = f0/Δf , where f0 and Δf are the central frequency and bandwidth (FWHM) of the resonance, respectively. A narrow bandwidth (high Q) excludes more noise and results in better signal to noise ratio. Q is also rela...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Review of Scientific Instruments
سال: 2016
ISSN: 0034-6748,1089-7623
DOI: 10.1063/1.4961573