MEMS sensor measurement of surface temperature response during subcooled flow boiling in a rectangular flow channel
نویسندگان
چکیده
منابع مشابه
Experimental measurement of heat transfer coefficient and mass of deposited CaSO4 in subcooled flow boiling condition
Fouling is a common, fundamental and costly problem in heat transfer systems, which reduces thermal efficiency of equipment, increases the energy loss and causes strong damage to the heat transfer equipment in various industries. The main causes of fouling on the heat transfer surfaces are salts with inverse temperature-solubility in the fluid which calcium sulfate is one of the most important ...
متن کاملCritical heat flux in subcooled flow boiling of fluorocarbon liquid on a simulated electronic chip in a vertical rectangular channel
Experiments are performed to correlate and model CHF during subcooled flow boiling of dielectric fluoro~rbon (FC-72) liquid on a smooth 12.7 x 12.7 mm* sirn~at~ electronic chip inside a vertical rectangular channel. Two distinct CHF regimes are established based on flow visualization and experimental data. At low flow velocities, CHF is accompanied by the formation of a continuous vapor blanket...
متن کاملDevelopment of a Numerical Model for Subcooled Boiling Flow
Population balance equations combined with a threedimensional two-fluid model are employed to predict bubbly flows with the presence of heat and mass transfer processes. Subcooled boiling flow belongs to this specific category of bubbly flows is considered. The MUSIG (MUltiple-SIze-Group) model implemented in CFX4.4 is further developed to account for the wall nucleation and condensation in the...
متن کاملModeling of Upward Subcooled Flow Boiling of Refrigerant-113 in a Vertical Annulus
In this paper, a modified two-fluid model has been adopted to simulate the process of upward vertical subcooled flow boiling of refrigerant R-113 in a vertical annular channel at low pressure. The modified model considers temperature dependent properties and saturation temperature variation and was validated against a number of published low-pressure subcooled boiling experiments. The results s...
متن کاملSubcooled two-phase flow boiling in a microchannel heat sink: comparison of conventional numerical models
Subcooled flow boiling in multi-microchannels can be used as an efficient thermal management approach in compact electrical devices. Highly subcooled flow boiling of HFE 7100 is studied in two microchannel heat sinks to choose a proper numerical model for simulating boiling flows in microchannels. Results of five different numerical models, including Volume of Fluid (VOF), Eulerian boiling, Eul...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Experimental Thermal and Fluid Science
سال: 2015
ISSN: 0894-1777
DOI: 10.1016/j.expthermflusci.2015.02.002