Melt blending of polypropylene-blend- polyamide 6-blend-organoclay systems
نویسندگان
چکیده
منابع مشابه
Crystalline and Amorphous Orientation of Polypropylene / Nylon 6 Blend Filaments
N6) made with or without PP-g-MAH as compatibilizer are investigated. The blend filaments produced at the take-up speeds of 300 and 800 m/min were drawn with draw ratio of 3.5 and 2, respectively. Effects of blending of N6 with PP on birefringence , crystalline, and amorphous orientation factors of the composite filaments are studied. The amorphous orientation factor, fam of PP was found to inc...
متن کاملMulti‐jet electrospinning of polystyrene/ polyamide 6 blend: thermal and mechanical properties
Introduction Electrospinning process is broadly used to obtain membrane-like webs with submicron to micron fibers (Li and Xia 2004). Electrospun nanofibers, with its large surface area and multiple pores, can be used to construct unique functional nanostructures for composites, filtration membranes, biomaterials, and breathable textile fabrics (Greiner and Wendorff 2007; Li and Xia 2004; Pham e...
متن کاملBlend Response and Stability and Cultivar Blending Ability in Oat
buffering capacity, that is, its ability to adapt to variable weather, insect, disease, weed, and soil conditions. Ways Genetic diversity in cropping systems can provide buffering against to improve a crop’s buffering capacity include intravarying environmental conditions. Therefore, cultivar blends may have greater and more stable yields than their pure-line components. population interplant b...
متن کاملBlending Landsat and MODIS Data to Generate Multispectral Indices: A Comparison of "Index-then-Blend" and "Blend-then-Index" Approaches
The objective of this paper was to evaluate the accuracy of two advanced blending algorithms, Spatial and Temporal Adaptive Reflectance Fusion Model (STARFM) and Enhanced Spatial and Temporal Adaptive Reflectance Fusion Model (ESTARFM) to downscale Moderate Resolution Imaging Spectroradiometer (MODIS) indices to the spatial resolution of Landsat. We tested two approaches: (i) “Index-then-Blend”...
متن کاملCurvature continuous blend surfaces
We describe a method to generate blend surfaces which t with continuous curvature to the primary surfaces. This blend surface is obtained as the bicubic tensor spline minimizing a variational problem. Among all the bicubic tensor splines which give a curvature continuous blend surface, the one is chosen which minimizes a bilinear functional. In Section 2 we summarize and extend the results of a...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Polymer International
سال: 2006
ISSN: 0959-8103,1097-0126
DOI: 10.1002/pi.2109