Mechanism of Wear in Vacuum (Wear of Steels at High Temperature (6th Report))
نویسندگان
چکیده
منابع مشابه
Delamination Wear Mechanism in Gray Cast Irons
An investigation of the friction and sliding wear of gray cast iron against chromium plated cast irons was carried out on a newly constructed reciprocating friction and wear tester. The tests were the first to be done on the test rig under dry conditions and at the speed of 170 cm/min, and variable loads of 20-260 N for a duration of 15 min. to 3 hours. The gray cast iron surfaces worn by a pro...
متن کاملThe relevance of wear-mechanism maps to mild-oxidational wear
The presence of oxygen in the environment in which a steel sliding system operates will promote a mild form of wear with wear debris consisting mainly of iron oxides. Of the oxidation-dominated mechanisms, mild-oxidational wear (the prefix describes the extent of oxidation and not the wear rate) has been most extensively investigated. In this paper, examples will be used to show that the wear-m...
متن کاملHigh Temperature Behavior of Dual Phase Steels
Dual phase steels with different martensite volume fraction and morphology were tensile tested at a temperature range of 25 to 5500C. Stress-strain curves of all steels showed serration flow at temperatures of 250 and 3500C, and smooth flow at the other temperatures. Both yield and ultimate tensile strengths increased with increasing testing temperature up to about 450<sup...
متن کاملInvestigation of Wear Mechanism in Quenched and Tempered Medium Carbon-High Chromium Martensitic Steel Using Dry Sand/Rubber Wheel
The aim of the present study was to investigate the effect of quenching and tempering temperatures on the microstructure, mechanical properties and the wear characteristics of medium carbon-high chromium wear resistant steel. In addition, the dominant wear mechanisms were studied. For this purpose, austenitizing and tempering temperatures were selected in the ranges of 900- 1000 °C and 300- 500...
متن کاملElectropulsing-induced steels strengthening at high temperature
Electropulsing usually reduces the stability of metastable phases in materials. This work reports the opposite effect, where electropulsing drives the stable -phase at high temperature to be decomposed. This enables both γ-phase and σ-phase in duplex stainless steel to survive and hence to strengthen the steel at high temperature. The hardness of the quenched sample after electropulsing is 49....
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Institute of Metals and Materials
سال: 1959
ISSN: 0021-4876,1880-6880
DOI: 10.2320/jinstmet1952.23.2_83