Mechanical-thermal noise in micromachined acoustic and vibration sensors
نویسندگان
چکیده
منابع مشابه
Micromachined Thermal Flow Sensors - A Review
Microfabrication has greatly matured and proliferated in use amongst many disciplines. There has been great interest in micromachined flow sensors due to the benefits of miniaturization: low cost, small device footprint, low power consumption, greater sensitivity, integration with on-chip circuitry, etc. This paper reviews the theory of thermal flow sensing and the different configurations and ...
متن کاملSurface Acoustic Wave (SAW) Vibration Sensors
In the paper a feasibility study on the use of surface acoustic wave (SAW) vibration sensors for electronic warning systems is presented. The system is assembled from concatenated SAW vibration sensors based on a SAW delay line manufactured on a surface of a piezoelectric plate. Vibrations of the plate are transformed into electric signals that allow identification of the sensor and localizatio...
متن کاملWideband micromachined acoustic sensors with radio frequency detection
Silicon micromachining techniques permit batch fabrication of microphones that are small, reproducible, and inexpensive. However, many such sensors have limited bandwidth or are too fragile to be used in a humid, wet, or dusty outdoor environment. Microphones using capacitive micromachined ultrasonic transducer (CMUT) membranes and radio frequency (RF) detection overcome some of the problems as...
متن کاملSurface-Micromachined Thermal Conductivity Gas Sensors For Hydrogen Detection
The undersigned hereby certify that they have read and recommend to the Fac-a thesis entitled " Surface-Micromachined Thermal Conductivity Gas Sensors for Hydrogen Detection " by Shuoxi Chen in partial fulfillment of the requirements for the degree of Master of Science.
متن کاملThermal characterization of a microheater for micromachined gas sensors
In this paper, a new four-point probe, double spiral heating element configuration for micromachined gas sensors is proposed and a simple analytical model of the steady-state thermal behavior of the microheater is presented. A testing procedure is suggested, based on simple two-wire and four-wire resistance versus power measurements, together with an iterative extraction procedure for the param...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEEE Transactions on Electron Devices
سال: 1993
ISSN: 0018-9383
DOI: 10.1109/16.210197