Mechanical Properties of Rapidly Stretched Copper and Copper Alloy
نویسندگان
چکیده
منابع مشابه
determination of some physical and mechanical properties red bean
چکیده: در این تحقیق، برخی خواص فیزیکی و مکانیکی لوبیا قرمز به-صورت تابعی از محتوی رطوبت بررسی شد. نتایج نشان داد که رطوبت بر خواص فیزیکی لوبیا قرمز شامل طول، عرض، ضخامت، قطر متوسط هندسی، قطر متوسط حسابی، سطح تصویر شده، حجم، چگالی توده، تخلخل، وزن هزار دانه و زاویه ی استقرار استاتیکی در سطح احتمال 1 درصد اثر معنی داری دارد. به طوری که با افزایش رطوبت از 54/7 به 12 درصد بر پایه خشک طول، عرض، ضخام...
15 صفحه اولMechanical properties of copper octet-truss nanolattices
We investigate the mechanical properties of copper (Cu) octet-truss nanolattices through a combination of classical molecular dynamics (MD) simulations and theoretical analysis. The MD simulations show that Cu nanolattices with high relative density are stronger than bulk Cu, while also achieving higher strength at a lower relative density as compared to Cu meso-lattices. We demonstrate that mo...
متن کاملMechanical Properties of Copper-Nickel-Titanium Archwires
MECHANICAL PROPERTIES OF COPPER-NICKEL-TITANIUM ORTHODONTIC WIRES Margaret Rosen, D.M.D. Marquette University, 2016 Introduction: The initial phase of orthodontic therapy relies on flexible wires, usually composed of a nickel-titanium alloy, to apply a substantially constant load during tooth movement. Copper has been added to nickel-titanium archwires, resulting in an alloy with potential clin...
متن کاملMechanical Behavior and Fracture Properties of NiAl Intermetallic Alloy with Different Copper Contents
The deformation behavior and fracture characteristics of NiAl intermetallic alloy containing 5~7 at% Cu are investigated at room temperature under strain rates ranging from 1 ˆ 10 ́3 to 5 ˆ 103 s ́1. It is shown that the copper contents and strain rate both have a significant effect on the mechanical behavior of the NiAl alloy. Specifically, the flow stress increases with an increasing copper con...
متن کاملInitial Stages of Oxidation of Copper and Copper-iron Alloy
The initial oxidation stages of copper and copper-iron alloys have been studied by the AtomProbe Field Ion Microscope (AP-FIM). The depth profiles of copper oxide formed in-situ were successfully determined. The composition of the oxide was close to the value of Cu20, but a large concentration fluctuation was found. The interface between the oxide and the metal was found to be diffuse, the widt...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Society of Materials Science, Japan
سال: 1969
ISSN: 1880-7488,0514-5163
DOI: 10.2472/jsms.18.643