Mechanical Properties Enhancement of the Au-Cu-Al Alloys via Phase Constitution Manipulation

Near equiatomic FeCo alloys: constitution, mechanical and magnetic properties

Alloys based on the near-equiatomic FeCo offer exceptional magnetic properties. The equiatomic alloy was ‘invented’ in 1929, it offers a saturation hardly lower than that of the maximum obtained for Fe-0.35Co, with higher permeability and a lower coercivity than the latter. However, this alloy remained without industrial application, mainly because of its extreme brittleness. Only with the addi...

Structure and Mechanical Properties of Al-Cu-Fe-X Alloys with Excellent Thermal Stability

In this work, the structure and mechanical properties of innovative Al-Cu-Fe based alloys were studied. We focused on preparation and characterization of rapidly solidified and hot extruded Al-Cu-Fe, Al-Cu-Fe-Ni and Al-Cu-Fe-Cr alloys. The content of transition metals affects mechanical properties and structure. For this reason, microstructure, phase composition, hardness and thermal stability ...

Effect of Minor Au Addition on Glass-Forming Ability and Mechanical Properties of Pd--Cu--Au--Si--P Alloys

The glass-forming ability (GFA), thermal stability and mechanical properties of bulk glassy Pd79Cu6 xAuxSi10P5 (x 1⁄4 0{6 at%) alloys were studied. The results revealed that the minor substitution of Au for Cu strongly affects the thermal stability and GFA of Pd–Cu–Au–Si–P alloys. The alloy in which 2 at% Au was added to substitute Cu (Pd79Cu4Au2Si10P5) exhibits the broadest supercooled liquid ...

Icosahedral phase stabilities in Al-Cu-Ru alloys.

INFLUENCE OF THE Al CONTENT ON THE PHASE TRANSFORMATIONS IN Cu-Al-Ag ALLOYS

The literature about alloys of the Cu-Al system is extensive, due to its practical use. These alloys are of low cost and present good strength and hardness, depending on the Al content. They are used for making sleeves, guides, seats, flanges, gear wheels and many other critical small parts, as electrolysis cell cathodes, circuit plates and casting moulds when high thermal conductivity is neede...