Mechanical performance of neutron-irradiated dissimilar transition joints of aluminum alloy 6061-T6 and 304L stainless steel

نویسندگان
چکیده

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Effect of Heat Input on Tensile Properties of Friction Stir Welded AA6061-T6 and AA7075-T6 Dissimilar Aluminum Alloy Joints

Friction Stir Welding (FSW) is a solid state process widely used to join dissimilar aluminium alloys. High quality and strength joints can be fabricated using this technique when compared to other conventional methods. The welding parameters play major role in determining the quality of the weld. This paper aims in presenting the effect of heat input on tensile properties of the joints between ...

متن کامل

Microstructure and Mechanical Properties of Dissimilar Friction Stir Welding between Ultrafine Grained 1050 and 6061-T6 Aluminum Alloys

The ultrafine grained (UFGed) 1050 Al plates with a thickness of 2 mm, which were produced by the accumulative roll bonding technique after five cycles, were friction stir butt welded to 2 mm thick 6061-T6 Al alloy plates at a different revolutionary pitch that varied from 0.5 to 1.25 mm/rev. In the stir zone, the initial nano-sized lamellar structure of the UFGed 1050 Al alloy plate transforme...

متن کامل

Feasibility study of friction stir welding of 6061-T6 aluminium alloy with AISI 1018 steel

The present work demonstrates that friction stir welding (FSW) is a feasible route for joining 6061 aluminium (Al) alloy to AISI 1018 steel. The weld has a good weld quality and is free of cracks and porosity. The tensile failure happened at the boundary between the nugget and thermomechanically affected zone of the base Al alloy, indicating that the weld has a higher joining strength. Despite ...

متن کامل

Two-dimensional Mapping of Residual Strains in 6061-t6 Aluminum Alloy Friction Stir Welds

The residual strain profiles were measured through the thickness of friction-stir welded (FSW) plates using neutron diffraction to study the relationship between the angular distortion and the residual strain distribution. Three different weld specimens were prepared from a 6061-T6 aluminum alloy with the purpose of separating the effects of the frictional heat and plastic deformation on the re...

متن کامل

Simulation of Material Plastic Flow and Morphology During Friction Stir Welding of Stainless Steel to Aluminum Alloy Dissimilar Joint

Today, steel to aluminum joints are used to facilitate transportation and fuel consumption. These joints are applied from nuclear, aerospace and naval to automobile and kitchen industries. According to previous studies fusion welding processes are not suitable methods for these joints, solid-state welding, especially friction stir welding, is a proper way to use for these joints. However, using...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Journal of Nuclear Materials

سال: 2018

ISSN: 0022-3115

DOI: 10.1016/j.jnucmat.2018.05.070