Mechanical Parameters Characterizing Interface Crack and Interface Strength Evaluation Testing
نویسندگان
چکیده
منابع مشابه
Cement-Implant Interface Fracture Failure by Crack Initiation Due to Interface Cavity Stress Concentration
Nowadays total joint replacements are widely used in the world, so in average 800,000 joint surgeries are done yearly only in Europe and North America. However implant loosening is and remains as the major issue of all implant failures and therefore causes revision surgery procedures. Studies and experiments have identified poor fixation of implants most likely is the main cause of long term im...
متن کاملFracture mechanical test methods for interface crack evaluation of electronic packages
The experimental determination of fracture mechanical properties of interface cracks is a substantial task for the design for reliability of electronic packages. As interface cracks are dominated by a mode mix between tension and shear mode (crack driving modes I and II) a mixed mode bending method was developed to adjust the ratio of the two modes (mode mixity). For a correct extraction of an ...
متن کاملStrength and Interface Analysis
fiber post (GFP) treated or not with phosphoric acid, silane coupling agent, and unfilled resin. GFPs were etched or not with 37% phosphoric acid and different surface coating applied: silane coupling agent, unfilled resin, or both. Composite resin blocks were built around a 4-mm height on the GFP. Unfilled resin (20 s) and composite resin (40 s) were light activated by a light-emitting diode u...
متن کاملThe Interface Crack Problem Foranisotropic
The two-dimensional interface crack problem is investigated for ani-sotropic bodies in the Comninou formulation. It is established that, as in the isotropic case, properly incorporating contact zones at the crack tips avoids contradictions connected with the oscillating asymptotic behaviour of physical and mechanical characteristics leading to the overlapping of material. Applying the special i...
متن کاملEffect of Apparent Fiber Strength and Fiber - Matrix Interface Properties on Crack Bridging in Cementitious Composites
This article proposes a new theory for predicting the crack bridging performance of random short fibers involved in cementitious composites. The current theoretical model for estimating crack bridging performance of Random Short Fiber Reinforced Cement Composites (RSFRCC) under tension is limited to specific constituent properties: friction dominant fiber-matrix interface and complete fiber pul...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of The Adhesion Society of Japan
سال: 2007
ISSN: 0916-4812,2187-4816
DOI: 10.11618/adhesion.43.443