Mechanical Characterization of CoCrMo Alloys Consisting of Different Palladium Ratios Produced by Investment Casting Method
نویسندگان
چکیده
منابع مشابه
Mechanical Properties of Magnesium Alloys Produced by the Heated Mold Continuous Casting Process
Investigation of the tensile and fatigue properties of cast magnesium alloys, created by the heated mold continuous casting process (HMC), was conducted. The mechanical properties of the Mg-HMC alloys were overall higher than those for the Mg alloys, made by the conventional gravity casting process (GC), and especially excellent mechanical properties were obtained for the Mg97Y2Zn1-HMC alloy. T...
متن کاملOptimization of Microstructure and Mechanical Properties of Al-A360 Produced by Semi-Solid Casting
Semi-Solid Casting (SSM) is a new process that could produce globular structures with mechanical properties. The cooling slope method (CLM) is a one of this process that was employed to produce the A360 feedstock. In this method, The dendritic primary phase in the conventionally cast A356 alloy has transformed into a non-dendritic one. In this paper, The molten alloy with the temperature (PT) o...
متن کاملCopper Alloys in Investment Casting Technology
S. Rzadkosz, J. Zych, A. Garbacz-Klempka, J. Kozana, M. Piękoś, J. Kolczyk, Ł. Jamrozowicz, AGH University of Science and Technology, Faculty of Foundry Engineering, Krakow, Poland M. Kranc, Foundry Research Institute, Krakow, Poland T. Stolarczyk, Copper Museum in Legnica, Poland This paper presents research results in the field of casting technology of copper and copper alloys using the inves...
متن کاملMagnetic Properties of Pr–Fe–Al Alloys Produced by the Metallic Mold Casting Method
The structures and magnetic properties of Pr–Fe–Al alloys produced by the metallic mold casting method were investigated. The Pr–Fe–Al alloy consisted of the amorphous phase together with the non-ferromagnetic Pr phase. Magnetic measurements confirmed that the origin of coercivity in the alloys was the amorphous phase. It was found that the Curie temperature and coercivity of the alloys were st...
متن کاملTribochemical Characterization and Tribocorrosive Behavior of CoCrMo Alloys: A Review
Orthopedic implants first started out as an all-metal hip joint replacement. However, poor design and machinability as well as unsatisfactory surface finish subjected the all-metal joint replacement to being superseded by a polyethylene bearing. Continued improvement in manufacturing techniques together with the reality that polyethylene wear debris can cause hazardous reactions in the human bo...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Acta Physica Polonica A
سال: 2015
ISSN: 0587-4246,1898-794X
DOI: 10.12693/aphyspola.128.b-149