Mechanical and tribological properties of Si and W doped diamond like carbon (DLC) under dry reciprocating sliding conditions

نویسندگان

چکیده

The mechanical and tribological properties of three types diamond like carbon (DLC) coatings, i.e., non-doped, Si-doped, W-doped DLC, are evaluated. Dry reciprocating sliding wear tests were performed to evaluate the effect frequency/velocity on friction, adhesion, wear. degree graphitization non-doped DLC increases with velocity, which results in a lower coefficient friction (COF), decrease rate. Si-doped however, exhibits distinct behaviour, increasing COF severe fluctuations at higher velocities. In Si-DLC frictional heating drives formation an oxide-rich tribofilm large amounts Si-rich oxide debris that both adhesive abrasive. tribofilm, lack surface graphitization, result via stick-slip fracture/wear mechanisms, significantly increased rates

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Ultrasonic characterization of mechanical properties of Cr- and W-doped diamond-like carbon hard coatings

Two ultrasonic nondestructive evaluation methods have been applied to systematically characterize the mechanical properties of nanostructured physical vapor deposited diamond-like carbon (DLC) ultra-hard coatings. A photoacoustic guided-wave technique is used to generate broadband surface acoustic waves (SAW) on the coating surfaces, and dispersion relations of the SAW for DLC coatings are meas...

متن کامل

determination of some physical and mechanical properties red bean

چکیده: در این تحقیق، برخی خواص فیزیکی و مکانیکی لوبیا قرمز به-صورت تابعی از محتوی رطوبت بررسی شد. نتایج نشان داد که رطوبت بر خواص فیزیکی لوبیا قرمز شامل طول، عرض، ضخامت، قطر متوسط هندسی، قطر متوسط حسابی، سطح تصویر شده، حجم، چگالی توده، تخلخل، وزن هزار دانه و زاویه ی استقرار استاتیکی در سطح احتمال 1 درصد اثر معنی داری دارد. به طوری که با افزایش رطوبت از 54/7 به 12 درصد بر پایه خشک طول، عرض، ضخام...

15 صفحه اول

Anti-sticking behavior of DLC-coated silicon micro-molds

Pure carbon(C), nitrogen(N) and titanium(Ti) doped diamond-like carbon (DLC) coatings were deposited on silicon (Si) micro-molds by dc magnetron sputtering deposition to improve the tribological performance of the micro-molds. The coated and uncoated Si molds were used in injection molding for the fabrication of secondary metal-molds, which were used for the replication of micro-fluidic devices...

متن کامل

Tribological behaviors of several polymer–polymer sliding combinations under dry friction and oil-lubricated conditions

The friction and wear properties of polyamide 66 (PA66), polyphenylene sulfide (PPS) and polytetrafluoroethylene (PTFE) sliding against hemselves under dry sliding and oil-lubricated conditions were studied by using a pin-on-disc tribometer. The effect of applied load and sliding peed on tribological behaviors of the polymer–polymer sliding combinations under dry sliding and oil-lubricated cond...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Wear

سال: 2021

ISSN: ['0043-1648', '1873-2577']

DOI: https://doi.org/10.1016/j.wear.2021.204046