Mechanical Alloying of Mg-Be.
نویسندگان
چکیده
منابع مشابه
Synthesis and thermal stability of nanocrystalline Mg-6Al-1Zn-1Si alloy prepared via mechanical alloying
Thermal stability and the kinetics of the grain growth of nano-crystalline Mg-6Al-1Zn-1Si alloy prepared via mechanical alloying (MA) were investigated. It started with elemental powders, using a variety of analytical techniques including differential scanning calorimetry (DSC), X-ray diffraction method (XRD), and scanning electron microscopy (SEM) coupled with energy dispersive spectrometry (E...
متن کاملInfluence of Alloying Treatment and Rapid Solidification on the Degradation Behavior and Mechanical Properties of Mg
Magnesium (Mg) has drawn increasing attention as a tissue engineering material. However, there have been very few studies of laser-melted Mg-Zn alloys. In this study, four binary Mg-xZn (x = 2, 4, 6 and 8 wt. %) alloys were fabricated by laser melting. The influence of zinc (Zn) content and technique on the degradation behavior and mechanical properties of Mg were discussed. Results revealed th...
متن کاملNano-Crystalline Mg(2-x)MnxNi Compounds Synthesized by Mechanical Alloying: Microstructure and Electrochemistry
Mechanical alloying of binary and ternary elemental powder mixtures with the nominal compositions of Mg2Ni and Mg(2-x)MnxNi (x= 0, 0.05, 0.10 and 0.15 at. %) were carried out in a planetary ball mill for various milling times of 5, 10, 15, 20, 30 and 60 h. X-ray diffraction and field emission scanning and transmission electron microscopy were used for the characterization of the milled products...
متن کاملImproved mechanical performance and delayed corrosion phenomena in biodegradable Mg-Zn-Ca alloys through Pd-alloying.
The influence of partial substitution of Mg by Pd on the microstructure, mechanical properties and corrosion behaviour of Mg(72-x)Zn(23)Ca(5)Pd(x) (x=0, 2 and 6 at.%) alloys, synthesized by copper mould casting, is investigated. While the Mg(72)Zn(23)Ca(5) alloy is mainly amorphous, the addition of Pd decreases the glass-forming ability, thus favouring the formation of crystalline phases. From ...
متن کاملMg–Y–Cu bulk metallic glass prepared by mechanical alloying and vacuum hot-pressing
We have studied the amorphization behavior of Mg85KxY15Cux (xZ20–40) alloy powders synthesized by mechanical alloying technique. The as-milled powders were mainly amorphous after 10 h of milling. The thermal stability of these Mg85KxY15Cux glassy powders was investigated by differential scanning calorimeter (DSC). The ranges of Tg, Tx and DTx are around 430–459, 467–497, and 30–46 K, respective...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society of Powder and Powder Metallurgy
سال: 2000
ISSN: 0532-8799,1880-9014
DOI: 10.2497/jjspm.47.641