Measuring Terminal Capacitance and Its Voltage Dependency for High-Voltage Power Devices
نویسندگان
چکیده
منابع مشابه
Evaluation of capacitance-voltage characteristics for high voltage SiC-JFET
Capacitance between terminals of a power semiconductor device substantially affects on its switching operation. This paper presents a capacitance–voltage (C–V) characterization system for measuring high voltage SiC–JFET and the results. The C–V characterization system enables one to impose high drain-source voltage to the device and extracts the capacitance between two of three terminals in FET...
متن کاملMeasuring the Power Dissipation Capability of High-Voltage, Low-Capacitance Ceramic Chip Capacitors
This paper describes a successful strategy for measuring the power dissipated by high-voltage, low-capacitance ceramic chip capacitors at frequencies typical of switch-mode power supplies. For these devices, the simpler techniques employed to measure the power dissipation of highcapacitance tantalum and aluminum devices prove inadequate, and a more fundamental approach is required. The various ...
متن کاملpower system voltage stability enhancement by high side voltage control
voltage stability may be improved by various control functions. in this paper, it is shown that how high side voltage control (hivc) may be employed for this purpose. two test systems, namely a 22- bus and ieee u8-bus systems are used to demonstrate the proposed tuning strategy for hsvc control parameters.
متن کاملPromise and Challenges of High-Voltage SiC Bipolar Power Devices
Although various silicon carbide (SiC) power devices with very high blocking voltages over 10 kV have been demonstrated, basic issues associated with the device operation are still not well understood. In this paper, the promise and limitations of high-voltage SiC bipolar devices are presented, taking account of the injection-level dependence of carrier lifetimes. It is shown that the major lim...
متن کاملUse of negative capacitance to provide voltage amplification for low power nanoscale devices.
It is well-known that conventional field effect transistors (FETs) require a change in the channel potential of at least 60 mV at 300 K to effect a change in the current by a factor of 10, and this minimum subthreshold slope S puts a fundamental lower limit on the operating voltage and hence the power dissipation in standard FET-based switches. Here, we suggest that by replacing the standard in...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEEE Transactions on Power Electronics
سال: 2009
ISSN: 0885-8993
DOI: 10.1109/tpel.2009.2016566