Measuring system for 3d measurement of surface roughness.
نویسندگان
چکیده
منابع مشابه
Validation on 3D Surface Roughness Algorithm for Measuring Roughness of Psoriasis Lesion
Psoriasis is a widespread skin disease affecting up to 2% population with plaque psoriasis accounting to about 80%. It can be identified as a red lesion and for the higher severity the lesion is usually covered with rough scale. Psoriasis Area Severity Index (PASI) scoring is the gold standard method for measuring psoriasis severity. Scaliness is one of PASI parameter that needs to be quantifie...
متن کاملAbsolute measurement of surface roughness.
In an interferometer which uses a reference surface, the measured surface heights correspond to the difference between the test and reference surfaces. To accurately determine the rms roughness of supersmooth surfaces, the effects of the reference surface roughness need to be removed. One technique for doing this involves averaging a number of uncorrelated measurements of a mirror to generate a...
متن کاملFabrication of New 3D Phantom for the measurement of Geometric Distortion in Magnetic Resonance Imaging System
Introduction: Geometric distortion, an important parameter in neurology and oncology. The current study aimed to design and construct a new three-dimensional (3D) phantom using a 3D printer in order to measure geometric distortion and its 3D reproducibility. Material and Methods: In this study, a new phantom ...
متن کاملFabrication of New 3D Phantom for Measuring Geometric Distortion in Magnetic Resonance Imaging System
Introduction: Geometric distortion is a major shortcoming of magnetic resonance imaging (MRI), which has an important influence on the accuracy of volumetric measurements, an important parameter in neurology and oncology. Our goal is to design and construct a new three- dimensional phantom using a 3D printer in order to measure geometric distortion and its reproducibility in...
متن کاملHigh-resolution micro-CT as a tool for 3D surface roughness measurement of 3D additive manufactured porous structures
Since commercially available profiling systems fail when determining the surface roughness of 3D additive manufactured porous structures, a novel protocol for surface roughness quantification of these porous structures has been developed based on high-resolution micro-CT images. The influence of the noise in the images and the spatial image resolution on the accuracy of the micro-CT-based rough...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Bulletin of Bryansk state technical university
سال: 2015
ISSN: 1999-8775
DOI: 10.12737/22854