Measuring strain in sheet metals
نویسندگان
چکیده
منابع مشابه
Bending-Unbending Analysis of Anisotropic Sheet under Plane Strain Condition
The mechanical behavior of cold rolled sheets is significantly related to residual stresses that arise from bending and unbending processes. Measurement of residual stresses is mostly limited to surface measurement techniques. Experimental determination of stress variation through thickness is difficult and time-consuming. This paper presents a closed form solution for residual stresses, in whi...
متن کاملBending-Unbending Analysis of Anisotropic Sheet under Plane Strain Condition
The mechanical behavior of cold rolled sheets is significantly related to residual stresses that arise from bending and unbending processes. Measurement of residual stresses is mostly limited to surface measurement techniques. Experimental determination of stress variation through thickness is difficult and time-consuming. This paper presents a closed form solution for residual stresses, in whi...
متن کاملCorrosion Properties of Structured Sheet Metals in Salt Environment
In the present paper the corrosion properties of structured sheet metals were investigated. The aim of this work is to determinate the influence of the structuring process on the corrosion resistance of sheet metals. For this purpose, these sheets were examined by accelerated tests in corrosion chamber. The investigation was carried out using salt spray test. The experiment was conducted for th...
متن کاملRolling induced Size effects in Elastic-viscoplastic Sheet Metals
Rolling processes for which the characteristic length scale reaches into the range where size effects become important are receiving increased interest. In particularly, this is owed to the roll-molding process under development for high-throughput of micronscale surface features. The study presented revolves around the rolling induced effect of visco-plasticity (ranging hot and cold rolling) i...
متن کاملSimulation of Kinetic Friction in L-Bending of Sheet Metals
This paper aims at experimental and numerical investigation of springback behavior of sheet metals during Lbending process with emphasis on Stribeck-type friction modeling. The coefficient of friction in Stribeck curve depends on sliding velocity and contact pressure. The springback behavior of mild steel and aluminum alloy 6022-T4 sheets was studied experimentally and using numerical simulatio...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: FME Transactions
سال: 2019
ISSN: 1451-2092,2406-128X
DOI: 10.5937/fmet1903477b