Measuring residual stress in finite thickness plates using the hole-drilling method
نویسندگان
چکیده
منابع مشابه
buckling of viscoelastic composite plates using the finite strip method
در سال های اخیر، تقاضای استفاده از تئوری خطی ویسکوالاستیسیته بیشتر شده است. با افزایش استفاده از کامپوزیت های پیشرفته در صنایع هوایی و همچنین استفاده روزافزون از مواد پلیمری، اهمیت روش های دقیق طراحی و تحلیل چنین ساختارهایی بیشتر شده است. این مواد جدید از خودشان رفتارهای مکانیکی ارائه می دهند که با تئوری های الاستیسیته و ویسکوزیته، نمی توان آن ها را توصیف کرد. این مواد، خواص ویسکوالاستیک دارند....
Residual Stress Measurement of 7050 Aluminum Alloy Open Die Forgings Using the Hole-Drilling Method
Since this project is a result of a class assignment, it has been graded and accepted as fulfillment of the course requirements. Acceptance does not imply technical accuracy or reliability. Any use of the information in this report, including numerical data, is done at the risk of the user. These risks may include catastrophic failure of the device or infringement of patent or copyright laws. T...
متن کاملDetermining the accuracy of measuring the thickness of steel plates using Compton scattering method
When there is limitation access to one side of the structure in industry, one of the best methods for thickness measurements is the Compton scattering. In this paper, due to the statistical behavior of dispersed beam counting, we discuss the accuracy of the measurement for steel thickness. Using the experimental method and comparing it with MCNP simulation code, the accuracy is obtained less th...
متن کاملDual-axis Hole-drilling Espi Residual Stress Measurements
A dual-axis ESPI hole-drilling residual stress measurement method is described. It has the advantage of evaluating all the in-plane normal stress components with similar response to measurement errors, significantly lower than with single-axis measurements. Experimental tests were done on a stressed specimen, and the results supported theoretical expectations.
متن کاملeffects of free edge interlaminar shear stress on the residual stresses of polymer composites using hole drilling method
in the traditional hole drilling method the in-plane stresses are studied in detail and the interlaminar stresses are not taken seriously. the interlaminar stresses on the free edge of composite materials are important and can cause matrix cracking and delamination. inserting holes in composite laminates causes free edges and it can induce interlaminar shear and normal stresses. in this researc...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: The Journal of Strain Analysis for Engineering Design
سال: 2019
ISSN: 0309-3247,2041-3130
DOI: 10.1177/0309324718821832