Measurement of Wood Cutting Forces during Bandsawing Using Piezoelectric Dynamometer
نویسندگان
چکیده
منابع مشابه
Investigation of Cutting Forces Superalloy Inconel 718
Since the cutting tools used in machining process of super alloys are subjected to high cutting forces, accordingly tools life is reduced, therefore improvement in alloys machining and reducing cutting forces to achieve longer tools life is an essential necessity. In this research, the effect of changes in feed rate on cutting forces in machining process of nickel based super alloys is investig...
متن کاملExperimental Measurement of NC Machine Tool Milling Cutting Forces
Experimental measurement of the cutting forces in milling processes can be a useful tool to validate standard and non-conventional milling models to be adopted in most industrial applications. As an example, such models can be used to design the machine tool components and fixtures, to choose the technological process parameters and to define process monitoring and diagnostic tools such as moni...
متن کاملA hub dynamometer for measurement of wheel forces in off-road bicycling.
A dynamometric hubset that measures the two ground contact force components acting on a bicycle wheel in the plane of the bicycle during off-road riding while either coasting or braking was designed, constructed, and evaluated. To maintain compatibility with standard mountain bike construction, the hubs use commercially available shells with modified, strain gage-equipped axles. The axle strain...
متن کاملAutomotive Transmission Efficiency Measurement Using a Chassis Dynamometer
−Automotive transmission efficiency measurements are usually performed on purpose-built rigs. A simple model was developed for calculating the overall transmission efficiency of passenger cars by using a chassis dynamometer. Wheel power and engine output were measured, and these values were used for calculations. The proposed method can only be employed for vehicles with manual drive because it...
متن کاملMain and Normal Cutting Forces by Machining Wood of Pinus Sylvestris
Although Pinus sylvestris L. is the most frequently analyzed wood species with respect to cutting forces in sawing experiments, the problem of prediction of reliable values of tangential FC and radial FN cutting forces for specific sawing conditions, according to the method employing a specific cutting resistance K (N·mm) and correction coefficients CR, C, C, CAP, CVC, CMC, CT, as expressed b...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Drvna industrija
سال: 2016
ISSN: 0012-6772,1847-1153
DOI: 10.5552/drind.2016.1433