Measurement of Tool Face Temperature in Orthogonal Diamond Cutting.
نویسندگان
چکیده
منابع مشابه
Study of Cutting Temperature in Orthogonal Milling
Finite Element Method (FEM) based techniques are available to simulate metal cutting processes and offer several advantages including prediction of tool forces, distribution of stresses, and temperatures, estimation of tool wear, and residual stresses on machined surfaces, optimization of cutting tool geometry, and cutting conditions. However, work material flow stress and friction characterist...
متن کاملEffect of cutting parameters on tool-chip interface temperature in an orthogonal turning process
The aim of this paper is to investigate the effect of cutting speed and uncut chip thickness on cutting performance. A Finite Element Method (FEM) based on the ABAQUS explicit software which involves Johnson-Cook material mode and Coulombs friction law was used to simulate of High Speed Machining (HSM) of AISI 1045 steel. In this simulation work, feed rate ranging from 0.05 mm/rev to 0.13 mm/re...
متن کاملCutting Forces and Tool Wear Investigation for Face Milling of Bimetallic Composite Parts Made of Aluminum and Cast Iron Alloys
Bimetallic parts are used in many industries for weight and cost reduction of workpieces working under high loads and wear. One application for this type of composite material is in automotive industry. In this work the tool wear and cutting forces in the face milling of bimetallic parts made of aluminum and cast iron were investigated. A356 and GG25 alloys that are common materials for bimetal...
متن کاملRevolution in Diamond Cutting: Laser Sawing of Diamond Crystals
Laser sawing of diamonds is beginning to revolutionize the diamond-cutting industry. Not only does the laser saw offer savings in time and money, but it also enables the cutting of material virtually unworkable by conventional methods and makes available an almost limitless assortment of fancy shapes. This article describes the components and operation of the laser saw, as well as the situation...
متن کاملCutting Tool Temperature Analysis in Heat-Pipe Assisted Composite Machining
Machining of advanced materials, such as composite, encounters high cutting temperatures and rapid tool wear because of the abrasive nature of the reinforcement phases in the workpiece materials. Ultrahard coatings, such as chemical vapor deposition diamond, have been used for machining such advanced materials. Wear of diamond-coated tools is characterized by catastrophic coating failure, plaus...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society for Precision Engineering
سال: 1998
ISSN: 1882-675X,0912-0289
DOI: 10.2493/jjspe.64.892