Measurement of Time-Dependent Water Surface Variation Using a Novel Stereoscopic Measurement Method
نویسندگان
چکیده
منابع مشابه
Altitude measurement using laser beam reflected from water surface
In this paper altitude measurement from water surface using laser beam is presented. Research data indicate that the reflection of infrared waves from water surface is about zero and it is less than 2% for visible radiations. Phase-shift and heterodyne technique was used for the measurement, and the laser beam ( mW p nm 10 , 700 = = l ) was modulated by a sine wave having a fixed frequency....
متن کاملA new method for determination of frothability of frothers by using water recovery measurement
A new method was introduced for frothing characterization of flotation frothers. Method uses water recovery to develop a new frothability index named water recovery index (WRI). New index was determined for some commercial frothers and results were compared with dynamic frothability index (DFI). Results showed that water recovery index values follow the order of A-65 13016 s/mol > DF-250 6292.4...
متن کاملA Novel Method for Human Astigmatism Formulation and Measurement
Astigmatism’s defect has not yet been formulated in Physics and medical physics books theoretically. In this paper, we are trying to formulate the astigmatism’s defect. The results of formulation show that “the degree of astigmatism is negative reverse the distance that vision’s condition of astigmatism’s chart lines change conditions in dimness angle from dimness condition at infinite distance...
متن کاملA Novel Method for Human Astigmatism Formulation and Measurement
Astigmatism’s defect has not yet been formulated in Physics and medical physics books theoretically. In this paper, we are trying to formulate the astigmatism’s defect. The results of formulation show that “the degree of astigmatism is negative reverse the distance that vision’s condition of astigmatism’s chart lines change conditions in dimness angle from dimness condition at infinite distance...
متن کاملResidual Stresses Measurement of a Quenched Cylinder using Slitting Method
Residual Stress measurement has gained interests among researchers for many years due to its great influence on the structural integrity. Slitting method is one of the destructive techniques that relies on the introduction of an increasing cut to a part containing residual stresses. Similar to all other mechanical strain relief techniques, slitting also suffers from its shortcomings during the ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Visualization Society of Japan
سال: 2006
ISSN: 1884-037X,0916-4731
DOI: 10.3154/jvs.26.supplement2_199