Measurement of Thermal Diffusivity of Intermetallic Compound TiAl Base Alloys.

نویسندگان
چکیده

برای دانلود رایگان متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Thermal-cycling creep of g-TiAl-based alloys

In two-phase TiAl-based alloys, the coexisting 2 and phases exhibit a thermal expansion mismatch, so that increased creep rates during thermal cycling may be expected. Creep deformation of two g-TiAl-based alloys was investigated during thermal cycles between 900 and 300 or 350 C with applied tensile stresses of 32.5 or 37.0 MPa. Measured thermal cycling creep rates were compared with isotherma...

متن کامل

Molecular Dynamics Study of Thermal Properties of Intermetallic Alloys

Molecular dynamics simulations of bulk copper, gold pure metals and their ordered intermetallics alloys of Cu3Au(L12) and CuAu3(L12) have been carried out between above 0 K and below the their melting points of the materials for predicting their temperature-dependent thermophysical properties. The effects of temperature and concentration on the physical properties such as enthalpy, volume, heat...

متن کامل

Microstructures and Mechanical Properties of NiAl-(Cr) and TiAl-(Cr) Intermetallic Alloys

The oxidation resistant light weight aluminides: NiAl and TiAl with ordered

متن کامل

Novel Measurement of Anisotropic Thermal Diffusivity

We describe a method for the measurement of thermal diffusivity of anisotropic materials. The technique uses a single pulse of light from a flashlamp on the front surface of a slap of material, part of which is shadowed by a rectangular mask. By fitting the measured rear surface temperature distributions as a function of time and space to a theoretical model, we obtain the thermal diffusivities...

متن کامل

Comparison of thermal diffusivity measurement techniques

Thanks to the collaboration between two laboratories, we present different techniques to measure thermal diffusivity. A brief description of any technique both in the experimental layout and in the processing algorithms is given. Results obtained on samples cut from the same block of stainless steel AISI 304, are reported. Uncertainty evaluation of any measurement is reported as well.

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Netsu Bussei

سال: 1994

ISSN: 0913-946X,1881-414X

DOI: 10.2963/jjtp.8.155