Measurement of the CMS Magnetic Field
نویسندگان
چکیده
منابع مشابه
Measurement and simulation of magnetic field strenght in the nano magnetic abrasive finishing process
Magnetic abrasive finishing can be classified as a non-traditional super finishing method for finishing surfaces with different shapes and working materials like flat plates, shafts, bearings parts, screws, tubes and many other mechanical parts that need good surface finishing properties. MAF is effective in polishing, cleaning, deburring and burnishing metal parts. The most important parameter...
متن کاملThe Measurement of Low Frequency Magnetic Field of Two Kinds of GSM900 Mobile Phone
Introduction: The use of mobile communication systems has dramatically increased over the past decade. Although many studies have been performed to determine the effect of radio frequency (RF) but less attention has been paid to the possible biological impact of exposure to extremely low frequency (ELF) components. The objective of this study is two folds. One is to design the ...
متن کاملMeasurement of the Earth’s Magnetic Field Vector based on zero field finding algorithm using optically pumped magnetometers
Atomic magnetometers have found widespread applications in precise measurement of the Earth’s magnetic field due to their high sensitivity. In these measurements, various methods have been utilized to compensate the Earth’s magnetic field in an unshielded environment. In this paper, we have proposed a method based on finding the minimum resonance frequency (corresponding to minimum magnetic fie...
متن کاملDistance Remote Measurement of Magnetic Field
Ján MOLNÁR, Irena KOVÁČOVÁ Department of Theoretical Electrical Engineering and Electrical Measurement, Faculty of Electrical Engineering and Informatics, Technical University of Košice, Letná 9, 042 00 Košice, E-mail: [email protected] Department of Electrical Engineering, Mechatronics and Industrial Engineering, Faculty of Electrical Engineering and Informatics, Technical University of Košic...
متن کاملMeasurement of magnetic field in dentistry.
The principal objective was to measure the magnetic fields occurring in dental surgeries at simultaneous subtraction of direct ground component of the magnetic field. A specifically designed instrument with the Hall probe was used for the measurement. It consisted of two amplifiers and a low frequency filter. Its task was to measure mean square values of the field (RMS) dependent on the positio...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEEE Transactions on Applied Superconductivity
سال: 2008
ISSN: 1051-8223,1558-2515
DOI: 10.1109/tasc.2008.921242