Measurement of strain rate near cutting edge by image processing on micro-cutting commercially pure alminum in SEM.
نویسندگان
چکیده
منابع مشابه
Experimental Study of the Effect of Laser-Cutting Process Parameters on Heat Distribution and Cutting Edge Quality of Steel Sheets
This study aimed to evaluate Laser-cutting process of Mild Steel St37 sheets with two different thicknesses. In order to evaluate the quality of cutting edge and the depth of the area affected by the heat, several tests were conducted to determine the effect of parameters such as Laser power, Laser beam movement speed and pressure of axillary gas on the quality of cutting edge and the depth of ...
متن کاملThe Effect of Power and Maximum Cutting Speed on the Material Removal Rate and Cutting Volume Efficiency in CO2 Laser Cutting of Polycarbonate Sheets
In the laser cutting process some well-known parameters, e.g. laser power and cutting speed, play major roles in the performance of the process. Each parameter or a combination of parameters can affect the material removal volume and cutting volume efficiency. The purpose of this research is to study the effect of power and maximum cutting speed on the material removal rate (MRR) and cutting vo...
متن کاملSurface Roughness Investigation of the Cutting Edge of the High Precision Cutting Tools Enabled by Micro and Nanometrological Measurements
The manufacturing technology of milling, drilling and turning tools have demands of new developing markets as well as quality and lifetime aspects of the machining. In order to achieve the high precision required by machining, the structure and form of the cutting edge of the tools must be investigated to provide the most influential properties. Correlation between the tool wear on the cutting ...
متن کاملHigh strain-rate response of commercially pure vanadium
To understand the plastic ̄ow behavior of commercially pure vanadium under high strain rates, uniaxial compression tests of cylindrical samples are performed using UCSD's enhanced Hopkinson technique. True strains exceeding 50% are achieved in these tests, over a range of temperature from 77 to 800 K at the strain rates of 2500 and 8000 sÿ1. The microstructure of the deformed and undeformed sam...
متن کاملThe Cutting Edge
“The bigger they are, the harder they fall” is a bit of wisdom that’s been around for a long time. But when it comes to pesticide application, the line should read, “The bigger they are, the closer they fall.” Large droplets are not as likely to drift off-target as smaller droplets. This basic principle lies behind many innovations to reduce drift when spraying herbicides. Nozzle manufacturers ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Japan Institute of Light Metals
سال: 1996
ISSN: 0451-5994,1880-8018
DOI: 10.2464/jilm.46.177